Denafrips Pontus II 1.4 Firmware

Mac or Windows?  I have the Mac version FPGA_EP4CE6F.  The last seven characters indicate the numbers on your FPGA in the Pontus.  I recall that the numbers need to match or you can brick your dac.  It’s also possible to brick it even with the correct update so be mindful of that.

Good to know!  I use Windows.  I will check the numbers on the FPGA and report back.  I appreciate your help!

--Jim.

I updated the firmware on my Gustard dac a few months ago.  The files are available on Gustard's website, but instructions are poor, at best.  I found a video that a guy posted on YouTube.  It was enough to help me figure it out.  Still, I was holding my breath and hoping I didn't brick the dac.  

After my intial post I checked and saw that the zip file contains both Mac and Windows update files.  You just need to verify the correct number on the FGPA.

Outstanding, thank you!  I will check as soon as I get home.  That should be on the daughterboard inside the case, correct?

I think so but I don’t recall it’s been a while since I did it.  There should be videos from Vinshine out in the world that go over the process.

@feckmo I'd recommend you reach out to Vinshine Audio and ask about the FW drivers.  I believe Alvin stated that they would continue to support owners that purchased their Denafrips products through them.

@feckmo 

Here's a link to the firmware update page on the Denafrips website:

https://www.denafrips.com/firmware-update-usb

*** DO NOT UPGRADE UNTIL ***

You verify the version of your FPGA chip. Look for the number on the programable “ALTERA” chip. I also have EP4CE6F. If you upgrade the wrong firmware version, you will “brick/break” your Pontus II.

If you like what you’re already hearing, don't mess with it. With Vinshine’s departure, I don’t know if Denafrips will support our older units and Vinshine can only do so much if you break it.

PS:  I personally prefer V1.3 over 1.4 

I confirmed my chip version - also EP4CE6F - and secured the upgrade file.  I followed the instructions and did the upgrade this morning.  All seems well and I will test in my system this evening.  Thanks to all for the input!

It’s my pleasure to be of service to you, my friends!

Alvin Chee 

www.vinshine.audio

For what it is worth, I have nothing but good things to say about Alvin and the fine folks at Vinshine Audio.  A class act all the way around.