Dedicated 20 amp circuit - Electrician laughed!


I brought my electrician out to my house today to show him where I would like to install a dedicated 20a circuit for my system.  He laughed and said that's the stupidest thing he's heard and laughs when people talk about it.  It said, if you're going to do it, you have to have it separately grounded (shoving a new 8 foot rod into the ground) but even then, he sees no way there can be an audible improvement.

Now, he's not just an electrician though. He rebuilds tube amps on the side and tears apart amps and such all the time so he's quite well versed in audio electronics and how they operate.

He basically said anyone who thinks they hear a difference is fooling themselves.  

Personally, I'm still not sure, I'm no engineer, my room's not perfect, and I can't spend hours on end critical listening...  But, he does kinda pull me farther to the "snake oil" side and the "suggestive hearing" side (aka, you hear an improvement because you want to hear it).

I'm not taking a side here but I thought it was interesting how definitive he was that this not only WILL not make a difference but ALMOST CANNOT make a difference. 
dtximages

Showing 1 response by drlisz

I think the dedicated 20 amp circuit is a good thing and #12 awg is sufficient unless the wiring is more than 75 ft from the panelboard then upsize to a10awg because of voltage drop +/-3%. Where the electrician would help is to make sure the house is PROPERLY grounded and the main wiring is connected well and tight. This will keep the power clean and if there is  a short or overcurrent you will not bring it across your equipment( amp, preamp etc.) Whole house suppression is good but at equipment is also helpful.I would also say when you wire the receptacle make sure the copper is clean and your connections are tight ( simple stuff we tend to overlook) can make a big difference. I have found many homes from the 40-90's wiring make work okay but grounding and bonding not suited best for electronic, audio, amp, etc.