2. speakers
  3. 1265570131

Dahlquist DQ-10 fuse holders and other upgrades?

I am refurbishing my DQ-10s that have been in storage for about 25 years. Years ago I "modified" these great speakers with a mirror image, ribbons, new tweeters, felt, and cap upgrades. I'm re-foaming the woofers and plan on replacing the binding posts and fuse holders, but I can't find high quality panel mount fuse holders anywhere. Any suggestions, as this seems to be a weak link after upgrading cables, posts and everything else? Also please advise as to any other suggestions to properly bring these great speakers back to useful life in the Twenty-First century.
tri_team
4 responses Add your response
mofimadness's avatar
mofimadness
4,982 posts
 
Try these guys:

http://www.regnar.com
mingles
796 posts
 
Remove the fuse. It's a relic from 20+ years ago that had it's place when speakers were inefficient, and underpowered amps were often driven into clipping which resulted in driver damage. If your amp is 100+ watts and you keep the SPL under 103 dB, the fuse is unnecessary. Dahlquist never published the sensitivity for the DQ-10s, but it's speculated to be about 85 dB.

You should check out the Dahlquist group over at Yahoo. A lot of good folks there that are willing to help:

http://tech.groups.yahoo.com/group/Dahlquist/

Best of luck!
hifitime
715 posts
 
Keep in mind that the new foam surrounds take a while to break in causing different bass (plus other?) characteristics
rtilden
156 posts
 
Yep, Mingles is right on. Back in the day, I inserted Fulton Brown copper wire sections in place of the fuses, which yielded a modicum of improvement in sound. I used a 250W per channel amp , and I cranked them up quite a bit without problem. I'm sure that today you can find even better fuse-bypassing options.
Log in to respond
More to discover
80x80
Kharma Exquisite Midi 2.1-S
80x80
Evolution Acoustics MM3
80x80
Focal Sopra 3's