rtilden

Responses from rtilden

Upgrading DC Cables for Linear Power Supply
Thanks, Jerry.  My wireless setup is a bit different than yours, but I understand your points re: separate LPS units and cumulative gains.  I will continue down the road you and SNS have helped clarify and see where it takes me.  I'm travelling so... 
Upgrading DC Cables for Linear Power Supply
Many thanks, Jerry, for the specific tips.  I think I will need a variety of BR and  AUVA EQ to swap around for a proper evaluation.  My amplifier's legs sit higher than the thickness of the BR Big Pads+, which I suppose means I will need to stack... 
Upgrading DC Cables for Linear Power Supply
Thanks for the response, SNS.  Yes, I was asking you and Jerry, as you have been gracious with your advice.  And I appreciate your explanation of all the variables in your system/room.  I was drawn to the Black Ravioli and Stack AUVA products due ... 
Upgrading DC Cables for Linear Power Supply
I've been researching and thinking about your comments re: isolation in my system (after 40 years- ha!).  Based on your experiences, can you tell me if this is a good path for starters?  I am thinking tiny, microphonic vibrations might better be h... 
Upgrading DC Cables for Linear Power Supply
Thanks Jerry & Thompson.  This is a bit cartoonish to me, as my Node was about $450, as I recall.  Now, with the Teddy Pardo LPS and Triode Wire Labs power cable, I am waaaay upside down on this thing.  It really doesn't bother me too much, bu... 
Upgrading DC Cables for Linear Power Supply
Thanks again, SNS.  I appreciate your help.  
Upgrading DC Cables for Linear Power Supply
Thanks for your reply, SNS.  These short DC cables are cheap enough, I will give them a try.  FYI:  I am using the Node N130 as a streamer only, to my Weiss 501 DAC.  Really quite good, IMO.  Let me ask another question: I thought I would try add... 
Upgrading DC Cables for Linear Power Supply
I know this is an older thread, but I am seeking guidance from folks who have compared 'Upgraded' DC Power cables with the factory offerings.  Specifically, I just installed the Limited Edition Teddy Pardo LPS for my Bluesound Node N130, and I am ... 
Amp recommendation in the $6000 range
Do not overlook CODA's 15.0 or 15.5.  Should be just right in performance and budget.  One of each is listed for sale now on Audiogon.  I love mine; it lacks nothing. 
Hot-Rodding Tyler's Woodmeres- SEAS Be Tweeters
Dennis- My emails to you bounce back. I was trying to send photos. I will just post the basic answers here. SEAS T29B001 Beryllium Tweeter Mundorf 5.6 Ohm Tweeter Resistor Mundorf 6.8uF Tweeter Capacitor Midrange Caps: Mundorf M-Cap Supreme 120uF... 
Hot-Rodding Tyler's Woodmeres- SEAS Be Tweeters
Be happy to help. Send me a personal message with your email and phone number, and I will review the process I used. 
B&W 'New' 800 Series
Hey Bo: I seem to recall you are located in the Netherlands. I live in Florida and travel for fun to Europe yearly. It would not be difficult for my wife and me to visit your haven of sound in one of our upcoming trips. Are you in a position to of... 
B&W 'New' 800 Series
Thanks, Mapman. Your reply is very good, and my experience is similar. I have heard both different speakers and different speaker cables make a difference in soundstage presentation, but I think your response is what I was looking for. 
B&W 'New' 800 Series
Thanks Bo. My question has nothing to do with B&W or any manufacturer of equipment. I was really trying to focus on front to back soundstage, within the realm of your experience with the 'best' results. Just wondering if I may be missing out o... 
B&W 'New' 800 Series
Hey, Bo: I have been following many of your different posts for a long time, and I think I know where you are coming from regarding realistic imaging and soundstage. I wanted to ask your thoughts on what I will call 'placement of stage'- in other ...