2. amps-preamps
  3. 178741-175948

Connect speakers to my new Denon AVR-x4700H Receiver or to my Outlaw 7125 7-Channel Amp

What should I do?  Should I can connect my speakers [5.1 plus an added zone 2] to my new Denon AVR-x4700H receiver, or pre-amp all channels from the Denon out to my Outlaw 7125 7-channel amp and power them that way?  Both units put out 125 watts per channel. If I pre-amp out to the Outlaw, Denon recomments I turn off the internal amplifier to reduce any interference.  I've no reason to think my Outlaw is in anything but excellent condition.  Speakers are all Paradigm Studios (40-v3, cc 470, ADP-470s), which I suppose are kind of vintage now.  All are rated at 8 ohm.  My hearing isn't great anyway, so I'll probably not be able to discern small differences in either setup.  My use is mainly movies and television (streaming services, some blu-ray disks) but I do listen to music too; just not as often.  I wonder if the Denon would appreciate if the Outlaw "took the heat"?  But I don't know what, if anything, I would give up to do that.  

If anyone has an opinion I'd love to hear it.

viralata
russ69's avatar
russ69
3,516 posts
 

Why don't you try both ways and see what the differences are? 

viralata OP
1 posts
 

Good point 

I was hoping to learn if there were any obvious advantages of either approach before spending the money for audilo cables to pre-out from the Denon to the Outlaw amp.

loomisjohnson
1,948 posts
 

my experience is that most  mass market avrs benefit from an external amp, which generally has more oomph than the internal amps in the avr. per russ69 i would compare both ways, but i'd be surprised if you didn't like the outlaw better.

oddiofyl's avatar
oddiofyl
3,879 posts
 

I had a 7125, great amp.... that's because ATI built it.     I would use the pre outs for sure.  

More to discover