Class D is just Dandy!

Hi @h2oaudio

Oh, agreed. In many cases a top octave roll-off may be much better sounding than a flat amp.

Also room dependent.

Best,


E

I have a new Red Dragon S500 I eventually will try out,haven't got too it yet,will be a diff. class d module then the ncore's I do have.
I will write a comparison review when I do try them.

Has anybody else tried this amp and what speakers do you use them with.

Kenny.

Hi John,

Thanks very much for the tip on the microphone and the software. I will check it out.  Sorry you have to give back the Scintillas.

Erik, Agreed. The room plays a big part as well and among other things.

Kenny, Looking forward to your review, especially the difference compared to the Ncore.

If anyone here interested in hearing the H2O, I am willing to send it for you to test drive in your system. No string attached of course. I would be very interested to read your review on the differences, especially compared to the Ncore and other icepower amps that you have.  Please remember though, the H2O has 8 kohm input impedance so you should have an appropriate preamp to drive it properly.

Henry

If it were possible to measure, I'd ask for these amps to be measured with a 1 Ohm resistor at 2.83 Volts. :)  About 8 Watts. Let's see that first.

REW is great, but measuring the speakers adds a ton of confounds. I say this as a speaker maker and integrator. And that's fine, but what I'm personally after is to understand how well these amps do electrically, as that will be the most clear.

If we try to measure just the speaker/room we won't have any idea what is due to the speaker, and how much is due to the amp/impedance interaction.

If I remember where my oscilloscope is I may do this with mine.

Best,


E

By the way, I just ran the numbers on that.

Based on output impedance, and assuming a 1 Ohm speaker impedance the ICEPower 250 A would droop around 2.2 dB at 20 kHz. That’s not unacceptable, and in line of what a tube amp would do to a lot of normal speakers.

Pro: A gentle glare reducing effect.
Con: Removes air, dulls top end.

A bigger concern to me would be the speaker efficiency and output power of the modules used.

Also, one not well known thing about these modules is that their cooling matters a great deal. The power rating increases with better heat sinks. Some manufacturers stick these in sealed speaker cabinets but the power gets derated.

Best,


E