CD transport warmup

I keep all my SS equipment powered up.

Agree with newbee. Leave it powered up, and your DAC as well. Also, play any kind of CD on repeat, constantly. That way the source components will always be ready for your listening. The CD mechanism, like any revolving technology will wear out less if it is running constantly and the bearings are running at their designed operating speed and temperature, compared with start-stop operation of 0-500rpm time after time, when cold. 

However, all of the above said, you still have to get your amps, analogue cables and speakers warmed up to hear the best out of them. If you have room temperature control, experiment with that too. I find the optimum (and still comfortable) room temp to be a constant 72-75 degrees F / 22-24C because this stabilises the air density and improves the air coupled performance of my speakers.

I WOULD NOT put my CD transport anywhere near a power amp. This is likely to degrade the sound due to EM & RFinterference.

An hour? Its either poorly designed or faulty, despite your assessing the probability of these things to be unlikely. Anything else that you mention is extraneous.

Hi.

Congratulations for a good ear and for a revealing system!

(I can only wish that i were able to hear that type of nuances.)

🥰

I have no clue what "needs to wake up" to make the transport to perform.

Maybe put it in a warmer spot like on top of power amplifier or something maybe then the warmup time will be shorter?🤔

actually CDs are making a comeback I knew this was going to happen right after LP started to make it come back that's why companies are still making CD players and transports.

@newbee 

+1… leave it on. You will not need a CD player much longer and as long as it is not spinning the electronics will last for a long time.

If your unit is truly 'off' your situation would be normal, I think, IME anyway. But I've never used this unit.

If it does not totally shut off, but goes into a standby mode, I don't know, you'd think that is what a standby mode is for. Personally, unless it generates a lot of heat, I'd just leave it on.