2. analog
  3. 154895-37539

Cartridge Tonearm compatibility

Hi,
I need some help calculating cartridge/tonearm compatibility. I am considering building a DIY turntable. I have purchased a Maglev table and a Jasmin motor from China on ebay. I am currently building a custom plinch and arm-board.I have purchased a Jelco SA750E tonearm. I am considering a Dynavector XX2MKII cartridge. I have looked at resonant frequency calculators but quite frankly they are above my knowladge. Would the Dynavector XX2MKII be a good match for the Jelco SA750E. The tonearm mass is 13.26gr. The cartridge weight is 8.9 gr and the cartridge compliance is 10 mm/N.
128x128garyr46
yogiboy's avatar
yogiboy
5,715 posts
 
The resonance frequency is about 8hz. That should be fine!!
Here ya go!
https://www.ortofon.com/support/support-hifi/resonance-frequency
yeti42's avatar
yeti42
287 posts
 
This makes it easy if you have the arm effective mass and the cartridge compliance at 10Hz
https://www.vinylengine.com/cartridge_resonance_evaluator.phpIf you only have compliance at 100Hx multiplty that by 1.7 and you'll be close enough or halve static compliance if that's what you know.


garyr46's avatar
garyr46 OP
6 posts
 
Yogiboy, Thank You!
garyr46's avatar
garyr46 OP
6 posts
 
Clarkster, Why the lol. Is that really necessary.
mijostyn's avatar
mijostyn
8,570 posts
 
Gary, forget about the math. Get a Hi Fi News test record and see what the actual resonance frequency is. I suspect you might have to add a little weight to the head shell. So, you add weight until you get the actual resonance frequency below 10 but above 8 Hz both vertically and horizontally.
More to discover