Bi amping with two different pairs of monoblocks

OP

With a gear like yours, you would need a good Pre-amp to drive them. suggest as posted above the Pass Labs Xp-32 , which accommodates Bi or Tri amplification. only when you are committed to this type of amplification. 

Otherwise, just use the schiit and a pair of Y connectors..

Active crossovers have been mentioned, and can have several benefits if the circumstances are right.  In most cases it requires bypassing the stock passive crossovers, which is a fairly big change to a set of speakers....certainly doable for many, but if the crossovers employ corrections, baffle steps, impedance compensations, zobel networks, etc.,the plot thickens.  Just swapping in a simple active crossover may have a very different effect than the passive crossover.  More advanced active crossovers could probably accommodate all of those, but it’s wise to not assume it’s a straight forward swap.  Plus some passive crossovers are excellent and are really fine tuned.  Food for thought if anyone is contemplating similar.

 

(Knotscott) My suggestion eases the BASS Burden of the high pass amplifier relying on the speakers existing crossover to fill the Original Designers aural goals. Most definitely if going full active crossover, I would go DSP crossover to allow all manners of parameters to adjust

The problem with DSP active crossover is you are stuck with the dac that the manufacturer happens to use.

I use the MiniDSP SHD as an active crossover, feeding two powered subs and a Benchmark AHB2 amp for the ATC SCM7's.  Digital is pass through to a Benchmark DAC3.