Considering the speakers are 96db and have powered bass drivers, I’d doubt you’re going to need it or see much improvement at all. you’re only using a fraction of the power of one amp let alone two. Honestly I doubt you’re using more than 2wpc of one amp. No idea why you would want a 240 wpc amp to drive tweeters and another to drive the midrange. Seems to me you’re going the wrong direction. That said if you have them try it.
Bi-amping McIntosh MC2120 and MC2125 with Klipsch RP-5
Hi all,
I have a MC2125 and just inherited an MC2120. These should be pretty much the same amp, except the MC2125 has meters.
I have AudioQuest quad wire (Robin Hood and SubZero) and was trying to figure out the best way wire trying to bi-amp.
Question (equipment below):
-Should I run the low post from each speaker to 1 amp (amp running as mono) and the highs from each speaker to the other amp?
Equipment:
Mofi Ultradeck —> Transparent Audio Super Phono Interconnects —> Sutherland 20/20 phono preamp —>Transparent ->Audible Illusions Modulus 3A tube phone stage —> AudioQuest Colombia —> McIntosh MC2125 —> Audioquest SubZero biwire and RobinHood Biwire —> old Klipsch RP-5 with powered 12”.
Thanks in advance for any suggestions on wiring!