Best Musical Sub

Maybe a good read would be JV's review in TAS of the JL subs with the Raidho speakers. He used dual subs placed close to and relatively in the same plane as the Raidho's. I use this type of placement with my speakers which are 1st order crossover in conjunction with Gallo sealed subs connected speaker level.
I'm no sound engineer but I think you may be discounting the benefit of physical time alignment (ie the woofer cones of the main speakers and the subs in the "exact" same plane versus the phase corrections you are making via electrical manipulation.
You could experiment with your one sub between the speakers or better yet buy another sub. Two is way better than one!

Room/speaker interaction is a challenge at low frequencies. Compared to the relatively minor frequency response differences between two different high quality subwoofer systems, what the room does to wreck their smoothness is huge. That's the main problem, so imo that's where the main focus should be.

In a large live-sound venue, you may at times want to cluster the subs together in front of the stage to avoid having a "power alley" down the center of the room, which would be where widely-separated subs combine in-phase (which would also happen elsewhere but in comb-filter-patterns across the rest of the room).

In a small room, often the opposite approach works well: Multiple smaller subs spread around the room. The end goal is the same: To avoid strong in-phase and out-of-phase regions that result in large peaks and dips. With this approach the subs' outputs are de-correlated relative one another. It's not as efficient from an SPL standpoint, but if smooth bass with good impact and pitch definition is the goal, the slightly reduced net efficiency is worth it.

With a distributed multisub system, each sub naturally generates a unique peak-and-dip pattern at any given location in the room, and the sum of these dissimilar peak-and-dip patterns is far smoother than any one alone. Also the spatial variation in the frequency response (variation from one location to another within the room) is significantly reduced. So if there is still a problem, like your 50 Hz dip, chances are it's a global problem and therefore a very good candidate for equalization.

Given your unusual room situation, it might make sense to distribute subs in the vertical as well as horizontal planes, which can take some creativity. Usually elevating one sub so that it's closer to the ceiling than to the floor will help, but with tall ceilings that much elevation may not be possible.

I have customers who report +/- 3 dB in-room measured response across the bass region (20-80 Hz) from a four-piece multisub system, without EQ. From your post I think some EQ may be needed in your case.

Just as clustering multiple subs in a large room is an acoustic solution to an acoustic problem, so too scattering multiple subs in a small room is an acoustic solution to an acoustic problem.

Duke
dealer/manufacturer

Yes, very good points . First the subs is correctly timed and in phase with the Wilsons. I am live sound engineer / system designer by profession. I use the same measuent system that I use for large PA's in arenas wich is Ration Acoustics Smaart. This software with proper mic and IO will show you phase traces among other things to prrfectly align the two sorces. You can even see the phase shift change as you change the X-Over frequency .
I tried higher x-over points but the JLF110 just doesnt sound good to me in my room at higher ones, currently it is set around 70.
The room most certainly has some issues. It is 14x22x a tall vaulted ceiling. I have a fair amount of room treatments but the tall vault just does what it want to with the bass. Wich is a long decay below 50 and a big dip at 50.
All that being said, the single 10 sub just does t sound right. Now with some recordings the Wilsons on there own are perfect, but with many older ones, they need a little help IMO with the low end .

At that level, stereo subs would work best. TBI Magellan vIII subs/amps are phenomenal and are the most room placement insensitive subs I've ever used. Used them with Avantgarde Duos and they kept up. The other option is a pair of Vandersteen 2Wq. They can be challenging to wire into a system depending on where the amp is located but set up properly they blend perfectly with the main speakers. Having owned WP8, I found the proximity to walls can really impact the mid bass. If you haven't moved them around you should give it a try.

What frequency/slope are you crossing at? Per Rhljazz, if you want that kick drum fundamental handled by the sub you'll need to cross high enough to route the signal accordingly. Depending on the slope you're using, that may well be north of 100hz. I also agree with Bob's observation re: the room. My own experience is that dealing with all these issues - time alignment, room nodes, crossover point, slope and phase, etc - makes it very difficult to optimize subwoofer set-up by ear.

I'm a digital room correction guy and - even tho Audyssey my get you drummed out of the audiophile club - believe that it dramatically increases the chance of excellent subwoofer integration.

Have you tried setting the crossover high enough to encompass the kick drum and time align the sub to the main woofers? You can do this by ear with trial and error. Clarity is maintained through the midrange without bass bloat. I really don't think you want to pressurize the room, but just have the impact, right?