Audio envy - dang!


I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC. 

I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.

I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s

Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.

The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”

And that’s just what I did.
last_lemming

@kclone In my experience speaker grounds go on the (-) or black side of speakers.  I have ground boxes wired on the (-) on one pair and ground purifiers on the (-) on another pair.  

@kclone, when I received my SP-14s in April 2024 all wiring was connected and all I had to do was plug in the one ground connector. I would describe my listening experience as clean, extended, and the cables simply get out of the way of the music. 

Lak, that is not the case with my set.  There are two wires coming out of the speaker cable, one for each side.  There is a separate wire that is not attached to anything that goes to the outlet ground connector.  I will give Captain a call

Anyone have experience using AE ‘s USB cable?  Any comparisons to other brands?  Just trying to get an idea how it stacks up to other brands. Currently using Audioquest coffee and might be time to upgrade.