All you have to do is keep the spades on the low frequency end of the biwire, and tighten them under the binding posts. Put banannas on the high frequency portion and push them into the corresponding post.
Any problems using biwire cbls on single post Spkr
I have single post speaker connections on my Klipsch Chorus II speakers. I am looking to buy a set of AudioQuest Crystal wires that are internal bi-wired with spades. My intentions are to put the 2 positive spades on the positive post and the same way for the negative. The Crystal is a very thick cable, can they be connected this way? Are there any sonic effects in doing it this way, Good/Bad?
Any responses would be greatly appreciated!
Any responses would be greatly appreciated!