Amplifier to complete a 7.1 channel system w/great stereo music performance?


I currently have a 5.1 channel system in my home theater media room using a Rotel RMB-1095 amplifier, which is a 5-channel amp w/200 watts per channel.  I have a Rotel RSP-1069 surround sound processor.  I want to complete a 7.1 channel system and want to add a nice 2-channel amp to my system.  I want to not only achieve a nice 7.1 channel home theater system for movies but I also like to listen to stereo music (mostly rock & roll music).  I would use the 2-channel amp for my front main LR speakers.  My two main front LR speakers are psb platinum T6.  My center channel is also a psb platinum series.  My main concern with this purchase of a 2-channel amp is with an emphasis on great stereo music first with home theater movies secondary using just the front LR speakers.  My Rotel 5-channel amp will power the center channel, LR side surrounds & LR rear surrounds.

With a $2,000 budget I have three 2-channel stereo amps I'm considering as follows:

1.  a used Krell KAV-2250 with probably no more than a 30 to 90-day warranty around $1,750
2.  a new Parasound A-21 Halo that I can get brand new for $1,995
3. or the brand new ADCOM GFA-575se model which can be purchased new for about $2,200

I'd like any thoughts, opinions or suggestions from any of you audiophiles on these amps or any other amps in the $2,000 range that you feel will give me great home theater sound on movies and improved stereo sound with music.  Particularly comments on comparisons or experiences anyone has had with any of these amps or others that you think might fit the bill.  Thanks!
dmlima
Just wrote a long response and got kicked out and lost it.  ARGH!!!  So I'm making this one brief(er).  I've been down this same road with a Rotel RSP980, so here are some thoughts from my experience. 

Adding a stereo preamp is just as -- and maybe even more -- important than an amp if 2-channel is your priority.  Just in case you're not aware, you can seamlessly add both into your existing HT setup without having to swap cables.

With your budget you can 1) add an amp, 2) add a preamp, 3) add both, or 4) add an integrated.  If $2000 is all you want to spend I'd go with #4 or #3.

The most cost effective would be the integrated route.  A used Hegel H160 (available here now) or used Parasound Halo Integrated would be big upgrades over what you have, and both have a HT bypass to easily integrate with your system (ask if you're not familiar with this). 

You could do good separates if you up your budget just a bit using this equipment:  There's a nice McCormack DNA 0.5 available for $700 and a Hegel P20 for $1650, which would probably be a bit of an upgrade over the integrated options above but would also require another pair of interconnects.

Next, if you're not opposed to spending more later, would be to spend the $2k on a good stereo preamp and add an amp later.  Reason for preamp first is that your amp is decent and you'll probably benefit more from a good pre that gets those low and sensitive line-level stereo signals out of the electronic morass of your prepro.  In my experience, and many others here agree, changing preamps actually makes a bigger difference than changing amps -- of course YMMV.  Anyway, you could go with the excellent P20 above that by itself will likely yield a big improvement in your stereo performance, or go with a Rowland Capri or Parasound JC-2, all of which have HT bypass and are available here now.  Can't see going wrong with any of these great preamps. 

My my last option would be to do what you're asking about (sorry) and get a $2000 stereo amp first and then add a good stereo pre later.  The A21 is a very nice amp that you can get used for $1500, and there are also Bryston 7B SST monoblocks available here for just a little more.  If it's me, there's a McCormack DNA 1 with Steve McCormack's Gold revisions within your budget that I would absolutely jump on (I have a DNA 0.5 with A revisions that are a step down from Gold I believe).  Again, can't go wrong with any of these IMHO. 

Yes, this is a shorter version of my prior post believe it or not.  My last piece of advice for these types of electronics is to buy used.  You'll get much more performance per dollar, and if you decide to upgrade later you'll take much less of a financial hit.  Whew.  Hope this helps and best of luck.  Peace out. 




Thank your for your comments, opinion & sound advice!  Clearly you have more experience in higher end audio than I.  Quite frankly I've never give much thought of using a stereo preamp or an integrated.  When I started my system the priority was home theater and the Rotel multi-channel amp & surround sound processor have served me well.  I am now looking to enhance stereo music performance on a limited budget. 

What I have right now is a Rotel 1095 five-channel 200W per channel amp coupled with a Rotel RSP-1069 surround sound processor.  The way I listen to 2-channel stereo music now is by simply bypassing through my surround processor, which eliminates any sound processing via the bypass mode on the RSP-1069.  My CD source component is a Cary Audio CD-308.

My question is, how/why will a pre-amp or integrated amp provide better performance than a nice 2-channel amp that I bypass through my surround sound processor?
Because you're still using the preamp section of the Rotel, which isn't on the level of a good dedicated stereo preamp and so will continue to be a bottleneck to achieving better sound.  One of the big surprises many new audiophiles have as they try different equipment is how big an impact the preamplifier has on the sound of a system.  Most of us come into this hobby underestimating its importance -- me included.  You've got some very good speakers that will appreciate and allow you to hear the difference as you add higher quality upstream components. 

When I added a better stereo preamp and got the Rotel out of the chain for 2-channel, everything sounded richer, fuller, and the soundstage expanded in all directions.  Individual instruments and vocals also took on an added heft, solidity, and presence that sounded much more real and lifelike rather than relatively thin-sounding facimilies.  On the top end there was more detail flushed out, yet the treble sounded less brittle and more refined overall.  I just mention this so you have an idea of the level of improvement you might expect to hear by adding a better preamp, and a better stereo amp will likely also add substantial benefits as well.  In this way a good integrated amp can kill two very big and important birds with one stone, while separates give you more flexibility and potentially better sound albeit likely at higher cost.  Either way, your 2-channel listening experience should become much more enjoyable and rewarding.  Do research and read reviews, listen to as much stuff as you can, and enjoy the journey. 
You could also do this, depending how much you live in the digital world. You could get Parasound A21 and pair it with a good, but simple preamp. You could get tge integrated Parasound which is a truly great piece of gear. You could get a Bluesound Vault 2 and rip all your cds and have a streaming component for 2 channel listening. I have a Bluseound Node 2, The A21 and the Parasound P3 preamp. All my digital music is on an external NAS. I can also play my cd player if I want to.