2. amps-preamps
  3. 1049118322

Amplifier speaker relay problems.

Hi, I am working on an Niko Alpha II amplifier it is an older amp with the two large VU meters on the front. There is a problem when powering up that one chanel may not work. I have tracked this down to a relay that is in the speaker output path and is 24volt dc with two normally open contacts. It is on a printed circuite board and I wish to change it as cleaning did not help and I am afraid it may be degrading sound when working if not providing a good path. I uderstand this relay helps prevent thump on powerup and the sound from dithering out on shut down. Thank You for any advice.
guycom
erik_squires
16,056 posts
 
Should also point out, you should not just replace the relay with a fuse.

The protection circuitry prevents turn on/turn off transients and DC protection which a fuse will not.
dsrjohn
8 posts
 
Realize that about the fuse. Just wonder if it is a relay issue or something upstream that causes the relay to engage. The contacts on the relay look perfect - gold plated and not dirty at all.
dsrjohn
8 posts
 
pics posted here
https://sound.stackexchange.com/questions/26998/what-is-the-click-noise-that-an-amplifier-makes-after-you-turn-it-on-off/42225#42225
imhififan's avatar
imhififan
2,181 posts
 
@dsrjohn
A friend has a Sony TA-F3A amp. She says it was acting up - i.e. after powering up, it would take quite a while before she would hear the characteristic click and she would get sound but now it never clicks.

Try replace C308 (100uF 25V) may solve the problem

https://www.manualslib.com/manual/1272547/Sony-Ta-F3a.html?page=5#manual
dsrjohn
8 posts
 
Why that one?
More to discover