2. amps-preamps
  3. 195459-101923

Amplifier recommendations for 86 dB Sensitivity Speakers

Hi,

I’m considering a pair of Technics SB-G90M2, they have good specifications on paper; however, my only concern would be their 86 dB sensitivity. 

My current amplifier is Cayin A100t, which according to its specs, outputs 70 watts into 8ohms. the Technics are 4 Ohms; so, I assume my Amp could deliver 100-140 Watts into 4 Ohms. Unfortunately, I couldn’t find more accurate information about my amplifier, and it only shows the output power at 8 Ohms equipped with KT-88 output tubes (mine came with EL-34s), therefore, it’s unclear what the real output powerat 4 ohms is.

Wondering if this tube amplifier would be a good match for these more demanding 86 dB speakers? I’m aware of impendence fluctuations and I know the Amp can drive them just fine, but I am not sure if 100 watt per channel -assuming that’s what my Amp can deliver into 4 Ohms- would be enough for these speakers to make them sound as intended, meaning, good sound quality.

(I don’t nor am planning to listen at high volume but have a larger room with high ceilings).

Below are the specs.

Many thanks,

 

Technics SB-G90M2 Speakers 

  • Type: 3-way floorstanding speaker with bass reflex
  • Woofer: 2 x 16 cm
  • Midrange: 16 cm
  • Tweeter: 2.5 cm
  • Sensitivity: 86 dB
  • Impedance: 4 ohms
  • Frequency range: 33 Hz – 90 kHz (-10 dB)
  • Crossover frequencies: 500 Hz, 3400 Hz
  • Maximum power handling: 200 W
  • Recommended amplifier power: 40-200 W
  • Dimensions and weight: 111.4 x 29.2 x 36.6 cm / 35 kg

 

Cayin A100T Integrated Tube Amplifier 

Power output: 70 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 65kHz

Total harmonic distortion: 1%

Input sensitivity: 480mV (line)

Signal to noise ratio: 89dB (line)

Speaker load impedance: 4Ω to 8Ω

Valve complement: 8 x KT88, 2 x 12AU7, 2 x 6CG7, 1 x 12AX7

Dimensions: 440 x 210 x 397mm

Weight: 29kg

mamifero

Showing 2 responses by glennewdick

glennewdick's avatar
glennewdick
1,807 posts
 

your amp has 4ohm taps so just hook it up to those and you should be fine at low to moderate levels. 

glennewdick's avatar
glennewdick
1,807 posts
 

"Indeed, the Cayin A100T has 8 and 4 Ohm taps, and I’m sure it can drive 86 dB speakers, however, since I couldn’t find information regarding its 4 Ohm output,"

 

Tube amps do not increase power at lower impedances like SS amps do. The output transformer matches the output of the amp to match the speaker’s impedance so it’s still 70wpc out of the 4ohm tap. But this also functions to match the speaker’s impedance to the amp much better. I think 70wpc should be enough if you’re not trying to rock out at 100db. Technic’s recommended power is well within your amps power output. Recommended amplifier power: 40-200 W

More to discover