Amp suggestions needed


I have a pair of Apogee Duetta IIs coming and i need an amplifier capable of driving them (as they are apparently UBER power hungry). I need to keep it under 1k. So far Ive been considering Aragon 8008bb, BAT VK-200, and Mccormack DNA-1.

Any suggestions would be appreciated!
woodenpeter
Yes, don't. I was one of the original Krell dealers, never used them with the Apogees, different time frame. Good for its time but obsolete now and costs a fortune to repair. A friend who does my repair work has been given at least one older Krell because they cost so much to recap. But get it in preference to the KMA 100s, sounded better and didn't blow up, as my 100s did twice.
I second the 8008BB.A friend drove Duetta Signatures to glorious heights with a big old Jeff Roland class A amp a few years back.
Stanwal, you are probably right. But I did have a freiend that used a set of DNA-1s to drive his Divas. Worked great.

I have also heard good things about the H2O amps w/ APogee full rnage speakers, but I have never seen or heard one in person.
I would consider those b&k m200 sonata monoblocks with mods;
should drive without a problem and be on the warm side;this has been by experience driving merlin 4b+'s with these amps.
I have the Duetta Sigs., it is the impedance more than the power you have to worry about. My Tandberg 3026a and Meridian 605s are both rated at 150 watts but the Meridian would drive them and the Tandberg would not. I don't think bridged is a good idea because bridging an amp usually limits its ability to handle low impedance loads. The hybrids are another case entirely, much easier to drive. The original Apogee , which was bigger and had an even worse impedance curve, worked very well with the Classe 25 watt class a amp. The tube units with transformers should work, I have never used them, I did use a custom hybrid with mosfet outputs that had about 100 watts and it worked fine. Look at power supply design and not rated output.
Wood, you have three great amps listed but I don't thnk that the BAT or McCormack have enough power to properly drive the Duettas. My choice would be to use (2) McCormack (or BAT) amps in bridged mode.

You might also consider a used Sonographe SA-400 amp - I used one with my Apogee hybrids for years with great results.