amp stands


Anybody have any good ideas on building this type of stand? I have mono blocks and they have to sit on my carpeted floor. Thanks, John
radiomanjh

Showing 1 response by 1953

Went to Home Depot and bought 2, 24" x 24" x2" smooth concrete pavers. Sealed them with primer then spray painted a sand based tread paint from Rustoleum. Then I applied a large sheet of damping material I got from NAPA to the bottoms. The things sit on top of 3, 2" high brass cones I got from Audio Advisor. They look fantastic, weigh about 60lbs each and are VERY inert. Best of all the total cost was less than $80 for the pair with $60 of that being the brass points and I had them done in an afternoon.