Nice work! Which cartridges are paired to the 4 arms? And how do you decide which one to use?
A Second Tonearm on an SME Model 10
I was brave today, and altered the tonearm panel that Lee Drage made to go with an Acoustand pod. First drilled a 28mm hole centred 55mm from the nearest end of the SME cut out. This I enlarged with a dremel drum sander to 29.4mm and checked it was a tight friction fit over the subframe tower of the Model 10 TT. I made a cut-out in out so it would not touch the motor. Then I drilled a 3/16" hole in the subframe and affixed it with a nut and bolt, using a shim under it as I tightened it to make sure it was level (checked using a bubble level). Replaced the subplatter, tightened it down and remounted the Series IV and London Reference. Adjusted overhang, VTA and VTF. Now enjoying the first record!
The panel drilled and cut-out made:
Mounted to the subframe and bolted on. A good, tight fit:
Ready to play:
The hardest part was getting out the four bolts that hold the subplatter to the subframe—a lot of Loctite on them! One down, and one to go, but I'll have to wait until my hands stop shaking.