yogiboy
Responses from yogiboy
| Why are Harbeth speakers expensive while its drivers are not. Ain’t nothin’ like dem JBL’s for playin’ Donna Summer at full throttle! | |
| Subwoofer cable question for those in the know... This manual has all the options for any subwoofer hookup!http://www.psbspeakers.com/content/160419102939-PSB_SubSeries_English_Owners_Guide.pdf | |
| I'm considering replacing my passive preamp with a tubes. Is it worth it? Here ya go!http://www.quicksilveraudio.com/products/line.html | |
| Looking for suggestions on a used amp or new. $2000/ budget @hilltop20 Add this FET amp to your list.30 day return policy!http://avahifi.com/products/power-amplifiers/synergy-amplifiers/home-theater-amplifier | |
| Value inquiry - Martin Logan Motion series +1 georgelofiList the Denon receiver separate! | |
| SME Tonarms, SOTA Vacuum Turntables, and 10" Records @jazzguy43 If you need a blank disc, check out Ebay for a Donna Summer 12" single side on the Casablanca label. You can get one for under ten bucks. I use this for adjusting anti-skate. | |
| Audiogon Anti-Lowball Offer setting If you don’t want lowballers, just list BUY IT NOW. That’s the way I always list an item! | |
| Time to upgrade the old Dual turntable, looking for opinions. Check this one out!http://www.hifigem.com/polytable.html | |
| Pre-amp to receiver? @reubent The PAT 5 is also a speaker selection switch!http://www.tonepublications.com/old-school/dynaco-pat-5-preamplifer/ | |
| Can I use this amp in my house? @folkfreak I stand corrected! | |
| Can I use this amp in my house? Your dealer told you wrong information. That amp does not use near 2400 watts. Here is the info showing 800 watts total . A 15 amp circuit is sufficient! https://www.cambridgeaudio.com/products/851/851a | |
| Why are Harbeth speakers expensive while its drivers are not. +1 grannyring! | |
| Qs about Bias The manual does not say no load. Where do you see that? It says zero signal conditions. Do you have a different manual than the one that has been posted? | |
| Qs about Bias I just took a look at the manual. You don’t have to disconnect the preamp.Just turn the volume down so there is no signal. Always keep the speakers hooked up or you will damage the amp! Where does it say to do bias adjusment with no load? I don't ... | |
| Qs about Bias Never disconnect the speakers. Most tube amps need a load when turned on! You should not worry about a few mv's with the tubes. |