yogiboy

Responses from yogiboy

Suggestions for my system
You should try the Harbeth P3ESR. I have owned both the C7 and the P3. In that size room I think you will find the the smaller P3 will give you outstanding results!Here ya go!https://www.bing.com/videos/search?q=harbeth+p3esr+review&view=detai... 
System Upgrade
Budget? Integrated or separates? 
System Upgrade
Sorry to say but I doubt anything will work but more power amplification to get those Harbeths to sing! 
System Upgrade
Others might be correct. You might want to drive those Harbeths with more than the 32 watts that the Leben provide! 
System Upgrade
The volume control set at the upper range of the dial is better than having it at the lower range. If that is the only problem you are having I doubt you need to change anything! 
Can I use 2 two channel amps to run a 3 channel system? leaving one side of an amp unused
If it is a solid state amp it should be no problem. If it is a tube amp you will need a dummy load resistor. To be safe whether it is a solid state or tube amp you should get one of these !https://www.parts-express.com/Search.aspx?keyword=dummy%20... 
KD 500 w/ Grace 707 arm. Stylus type.
Many moons ago I owned that table and arm. Any Grado is a perfect match for the 7 gram mass 707. BTW, that KD 500 is an outstanding table!! 
A new turntable under 500-700euros
There is no new DD table within your budget with the features that you are looking for. If you don’t want to buy used you are just spinnin’ your wheels! 
What is the protocol here?
You are not being unreasonable. It would sure piss me off! 
Buyer request to delay shipment after purchase
It seems like a legitimate request. As long as you have been paid, why the worry? 
Cassette tape
Here ya go!https://www.marketplace.org/2017/11/22/cassette-tapes-make-comeback/ 
A "How To" question on Sunfire SDS 12 set up. Any advice welcome.
The way you have it hooked up now, you are running your speakers full range. If go from the preamp into the line in on the sub then out from the line out on the sub to the inputs to the amp then you will be using the high pass filter option that t... 
totem arros and amplification
The Sphinx is a good choice! 
help........
There is no low gain substitute for the M8080 ( 6C4 ) tube. I use this SCHIIT SYS to attenuate the output of my CDP. It’s worth a try! https://www.schiit.com/products/sys 
Increasing volume
@infection Did you contact Octave? You have too much gain. What power amp are you using? What speakers are you using? Did you always have this problem?