yogiboy
Responses from yogiboy
| Denon POA 1500 To drive 4ohm 86 dB Dynaudio 42se bookshelves You don’t have to take a picture. If the 230V version says to use 8 ohm speakers then you should only use 8 ohm speakers. You can give it a try and see if the amp does not shut down. Here is the owners manual! http://revintages.com/download/04_Den... | |
| Denon POA 1500 To drive 4ohm 86 dB Dynaudio 42se bookshelves Not on this one. The rear is labeled speaker A or B 4-16 ohms. Could they have changed that on the one that you have? https://img.canuckaudiomart.com/uploads/large/385147-21acc70f-denon_poa1500_power_amp.jpg | |
| Denon POA 1500 To drive 4ohm 86 dB Dynaudio 42se bookshelves The rear of that Denon says A or B 4-16 ohms and A and B 8-16 ohms. If you are using one pair of 4 ohm speakers there is no problem! | |
| Tubes? I stand corrected! | |
| Tubes? What tube amps are rated at 300 watts? I've never seen one! | |
| 4 ohm speakers, 2, 4 or 8 ohm taps on amps Hope the OP is still following this 14 year old thread! | |
| Speaker advice for first hi-fi setup - Monitor Audio Gold vs. KEF R series! I’ve owned many Harbeths and Spendors. My keeper of all of them is the Harbeth P3ESR. The specs are very deceiving (75 HZ). The base is sufficient without using a subwoofer. With a nice pair of stands they will fit into your budget.You should be a... | |
| Margin on speaker sales by high end dealer Or for that matter, any other type of business! | |
| If a speaker stand is mass-loading, how much does it matter what they're made of? @ hilde45 I own both of those brands. I use the Pangea DS 400 28" high with my Harbeth P3s. Since your speakers are 20" high you should try to get the shortest stand that you can find. You can always make a short stand taller but you can’t make a ... | |
| If a speaker stand is mass-loading, how much does it matter what they're made of? These 20" high Pangea LS 300 stands should fit the bill. They sure won’t break the bank! https://www.audioadvisor.com/prodinfo.asp?number=PGLS300&variation=20If you want 22" high stands the Sanus is another option!! https://www.audioadvisor.co... | |
| What tube amp for Harbeth 40.1 Any Harbeth that I have owned sounded great with Quicksilver amps!! http://quicksilveraudio.com/amplifiers/ | |
| My used Magnepan 1.6's are missing sparkly treble. Why? You should post your question at Planar speaker asylum! I'm sure you will get some information over there! https://www.audioasylum.com/cgi/etv.mpl?forum=mug | |
| My used Magnepan 1.6's are missing sparkly treble. Why? Are the jumpers that connect the high and low in place? Is the fuse okay? http://www.magnepan.com/pdfs/manual/MG_1.6.pdf | |
| Line Stage Preamplifiers AX vs AU The 12BH7’s are the driver tubes in my power amps. I am not using them in my preamp! | |
| Cable connect to Harbeth 30 2.0 I use this product to double up my cables. It makes it a lot easier. Good luck with your new Harbeths! https://www.audioadvisor.com/prodinfo.asp?number=AQ1002G |