tls49
Responses from tls49
| FM tuner problem Assuming you are using the antennas(AM & FM) that came with the unit, have you tried the AM? | |
| Follow up questions regarding my NAD C375BEE Pgawan2b, I do think you are offering good advice, however, the part about looking at the fuse makes no sense. That is an AC power fuse, so if it is blown, the unit will be totally dead and not work. The unit works, but with the protection circuit... | |
| Follow up questions regarding my NAD C375BEE Could the protection circuit activating be caused by excessive heat? A basic question, but I must ask if there is plenty of room around the NAD, top and both sides? Is it in a cabinet? | |
| Hubbell 5362W vs. 5362WWR You are welcome, and I think you made the right decision. | |
| How loud is loud? Wrong details like this drive me crazy at work!Then here is another one.dB/W/m is an efficiency spec.Actually, that is the sensitivity spec. And yes, I know many seemed to be confused about this, and even some manufacturers list it as efficiency, ... | |
| Best way to switch between AVR and Amp? What if I plug in my Arcam integrated amp into the 2 pre-amp front channel RCA inputs in the back of the yamaha receiver?Those front channel RCA's are outputs, not inputs. The only way to connect the Arcam and Yamaha together is to let one act as ... | |
| Pass Labs XP-20 using pass thru for home theater Manual is correct, front L & R outputs from the Arcam to input 5 on the XP-20, and rear L & R outputs from the Arcam to the other amplifier with rear speakers. Then set input 5 to pass through. This creates a unity gain in the XP-20 for th... | |
| Best way to switch between AVR and Amp? Sorry Yogiboy, I can't see the Niles SS-4 (4 in - 1 out) offering any advantage over the Niles DPS-1 (2 in - 1 out) in this application to switch 2 amplifiers. Also, both of those units only accept a maximum of 14 gauge bare wire, so the OP's 12 g... | |
| Hubbell 5362W vs. 5362WWR WR is weather resistant, but not exactly sure how they would be different to meet the specification. Obviously, corrosion is the issue, so maybe different materials, plating, etc. | |
| I need some speakers identified. Looks like this is your first post. Maybe your first thread should have been,"Need help posting links to pictures."Sorry, but hope you understand you can only post a link to a picture here, and not the actual picture. | |
| Audio Research REF 110 or Ref 75 Vdosc, take a look at this Wilson Watt Puppy 6 review. Just above the section titled "Comparison" is a comment from Dave Gordon at Audio Research that talks about using the 8 ohm tap on the amp even though the speaker is 4 ohm. Even if you decide ... | |
| Cary 805 vs 211 amp I must agree with Brf, as the 800 Diamond is not a good match for tubes due to the extreme variations in its impedance and phase angle. Take a look at the graph here. | |
| what amp under a grand? and if is not enough a year from now, i could always get another one and bridge them.Sorry Jughead, that's a bad idea. Minimum speaker load impedance for the a23 in bridged mode is 8 ohms and your speakers are 4 ohms. The a23 may work initially, b... | |
| McIntosh c2300 remote: will it work with mac cd Do you have the "DVD Data Port" on the C2300 connected to the data port on the MVP861? | |
| Cleaning lady and vacuum crime scene tape ?Hopefully you will find a solution to the problem before your emotions escalate with the Cleaning Woman. |