ricred1
Responses from ricred1
| REL subs with Rowland Amplifiers daveyf,You are correct my Signal cable has the red and yellow cables together and each cable has a Speakon end at the sub and a red/yellow connector and a black connector ( at the amp end). | |
| REL subs with Rowland Amplifiers Al,I’m assuming if the Signal Cable is picking up EMI from something nearby to cause the hum, adding an external ground screw on my amplifier won’t eliminate the hum?Silly me the hum is being caused from the REL not being grounded. When I connect ... | |
| REL subs with Rowland Amplifiers I've already sent Rowland an email requesting the cost of adding an external ground screw. Hopefully they will respond tomorrow and I will ship my amplifier to them before the end of the week. | |
| REL subs with Rowland Amplifiers daveyf,You do realize that the .1/LFE and low-level inputs are different? Although I didn't use .1/LFE I thought it was understood I wasn't referring to the low-level input. Since you won't listen to me, I have attached emails that I received dire... | |
| REL subs with Rowland Amplifiers Al,Is there a logical reason why when both subs are connected through the high-level input with the REL supplied speakon cable no hum is audible, but when I use the Signal speakon cables the hum is clearly audible? This is with no RCA cable co... | |
| REL subs with Rowland Amplifiers davefy,"I did notice that Richard turned down the low level connection...BUT I believe that the connection to the low level bypasses the connection to the high level once the RCA ic is connected to the preamp/sub. Since he had sound, I would suspe... | |
| REL subs with Rowland Amplifiers davefy,If you read my post dated 9-21-2019, "I have been corresponding with Justin Magana who is REL’s Chief Engineer. Based on his advice I twisted the red and yellow wires together and connected my REL via the high-level input. The black wire is... | |
| REL subs with Rowland Amplifiers Update from my last couple of posts. I haven't sold my Signal cable, so I decided to try the high-level input again. The last time I did, I had a RCA cable going from both RELs LFE(volume turned all the way down) to the preamp out, while connectin... | |
| Paradigm 3f, KEF reference 3, Monitor Audio PL300II verdantaudio,The Audiogon community would benefit greatly if more of us responded with the knowledge and responsibility that you display with your posts. You answered the question by describing differences without degrading either speaker or anyon... | |
| Paradigm Persona 3 vs 5 vs Monitor Audio I'm not anti anything in audio. I have as much a right to post my opinion as you do. I'll count how many positive post you have about personas compared to my negative post about them. I think we both know how the numbers will look. I don't trash a... | |
| Paradigm Persona 3 vs 5 vs Monitor Audio There are several that have found every Persona, Magico, Wilson, etc thread and said they're the best thing since slice bread. Are they unethical also? An opinion that's different from yours or mine doesn't mean it's unethical. | |
| Paradigm Persona 3 vs 5 vs Monitor Audio What’s a joke is not respecting an opinion that’s different than yours. It’s a subjective "hobby", we hear differently and have different preferences. So, if I post a lot highlighting how great Personas are that’s great, but post five bad things a... | |
| JL Audio F112 v2 subwoofer - worth the price? It comes down to your room, equipment, and preferences. e.g. michaela posted: " I had Rel and Velodyne subs and I think the JL’a just sounded so much better to my ears." I just went from a JL Audio F112 v2 to a REL Carbon Limited. My system sound... | |
| REL subs with Rowland Amplifiers daveyf,Jeff Rowland and I talked for several minutes about REL, but it isn't my place to post our discussion. I reached out to REL again this morning to make sure I wasn't missing something regarding how the subs were connected. I have no problem ... | |
| REL subs with Rowland Amplifiers As I mentioned earlier, one REL representative said because the high-level and low-level input uses the same board there's minimal difference in sound quality between the two, while another REL representative suggested the high-level input was 10... |