markd51
Responses from markd51
| Height of VPI Stainless HW-19 LP Clamp? Hi again, Had my BDR Clamp buttoned up with my 180-200gm Mofi LP's, I'd be set, as it's a much lower profile Clamp, but it won't.I caled both VPI this morning, and tried getting ahold of BDR, but had no luck with BDR. I had to leave a message.Mike... | |
| Height of VPI Stainless HW-19 LP Clamp? Hi, I must've been 1/2 asleep this morning when a measured with the dial indicator! lolRe-measuring again, with a conventional Tape Measure, I come up with almost precisely 1-5/8"So then, I'm gathering that the newer Delrin-Stainless one piece tha... | |
| Height of VPI Stainless HW-19 LP Clamp? In my attempts to lower the entire platter/plinth to gather more clearance with the 1 Piece Delrin Clamp, I have adjusted the bearing well plug as low as it can safely go, without causing rubbing between the Bearing Flangem abd Bearing Well Flange... | |
| Height of VPI Stainless HW-19 LP Clamp? High Jameswei,Thank you very much for your response.The measurement I get with my VPI black all Delrin 1 piece deluxe Clamp (Actually two pieces conjoined) is 1.766" tall with my dial indicator.I gather then, that the newer Deluxe 1 piece Clamp wi... | |
| Height of VPI Stainless HW-19 LP Clamp? Hi again,To elaborate a bit more, I am speaking of the current Deluxe VPI Spindle Clamp which has the Delrin Base-Bottom, and the Stainless Steel Knob on top. Thank you, Mark | |
| VPI HW 19? There was a spare AC motor for sale here in the classifieds around the 3rd, or 4th of this month, and in fact, it was listed by the same Audiogon seller whom I bought my MK-IV Platter from (user ID JDolgin) He listed it for a very inexpensive pric... | |
| VPI HW 19? Hi, Fairmountdan,Unsure what upgrades you're considering?I myself have no idea to what extent of replacement parts VPI still has available for the 19 Series?Probably, the most important parts that would be maybe needed down the line due to failure... | |
| I don't know where else to post this...so, Do a search for Littlite Mark | |
| Mk-IV Platter on a HW-19 JR Table? Hello all,Yes, you are right, that calling VPI, and getting the dope straight from the horses mouth is usually best.Since it was after hours, and I needed to sort of make a snap decision on buying this platter from a Agoner I thought I'd ask you f... |