luisma31
Responses from luisma31
| FR64S tonearm overhaul Luis, I'd like to recommend you to replace arm lift on FR-64s, got mine from Italy, made especially for FR-64s,Thank you Chak, I already did based on your recommendation from before, wonderful piece... | |
| FR64S tonearm overhaul Dear @luisma31 : Always is healthy to have the lower capacitance in that kind of operationsl cable and in the other side silver is better signal conductor than cooper and you want that the cartridge signal goes out of your speakers with the hi... | |
| Denon DA 307 and DA 309 Hmmm, something is not rightThank you @cleeds you are correct, my bad, I was mistakenly naming VTA to SRA | |
| Denon DA 307 and DA 309 Thanks | |
| Denon DA 307 and DA 309 The trick is to set up the VTF right with the brush. Correct, I'm not using the brush, it makes the stylus contact more complex and I wanted to initially try without it, planning on adding it later on. If you're using your Pickering with the brus... | |
| Denon DA 307 and DA 309 After installing the 3000SP with headshell provided courtesy of @chakster 1. Readjusted P2S which wasn't properly setup the 1st time to 230 mm. 2. Move back the cart a little on the HS to match 14mm overhang 3. Measured VTA, it is at 89 degrees, I... | |
| Denon DA 307 and DA 309 @lewm you were right about having fun setting up this tonearm.1. Measure 230mm P2S2. Figure out 14mm overhang from spindle to stylus3. Align the cantilever with the lines on the protractor4. Adjust the VTF5. Then after all this try to figure out t... | |
| Denon DA 307 and DA 309 I have been thinking that the combo of the Zupreme headshell 12g + DL-301II 6g for total 18g might not be the best for the DA-307.The DA-307 could accept carts from 5 - 10g so it seems the DL-301II could be a possible one to use, the original head... | |
| FR64S tonearm overhaul Have a question in regards to capacitance, apparently silver provides way better low capacitance than copper, however the capacitance parameters just seems to affect MM not MC. Is it really that critical lowering down capacitance let's say 1 meter... | |
| Supratek Owners Thread @cal3713 yeah I am that user, need to add that the DHT sound is very pleasant and I could listen and enjoy it very much as it is very special, just not on a daily basis. | |
| Best DAC After that you have Holo May and Denafrips Terminator | |
| Best DAC It depends on your budget but for pure delta sigma dac go with (as someone recommended) rme adi-2 (be sure is the Rev 2),if you can stretch some more holo audio spring 2 is an excellent R2R ladder dac | |
| Never Owned a Tube Amp and Want Advice OP, As larryi said sibilance is present in many recordings, no matter what you do is inherently in it, probably not what you listen to but Marc Anthony - Flor Pálida and A-ha - unplugged Hunting High and Low could show you some sibilance which is ... | |
| Denon DA 307 and DA 309 Just noticed your response, seems I wasn't following the thread. There is no horizontal movement, if you engage the antiskate yes it moves outwards as it should, the tonearm hasn't been overhauled. As a matter of fact I'm a little disappointed, th... | |
| Is there a Solid State amp that can satisfy a SET guy? Happy Thanksgiving everyone, listening to my mp-1 and MA-1s right now, some Michael buble (wife likes it) God bless you all (haters and trolls included) |