jperry
Responses from jperry
| Kickstarter for "The Turn" on vinyl - question Interesting question. If the sound is better I would prefer 4 sides. If the sound is the same take a look at the Black Dub album, which is 3 sides, with the 4th embossed with a pattern. I am already one of your backers and wish you success with yo... | |
| Stylus cleaner Magic eraser. Search the archive. | |
| "The Turn" - Kickstarter for vinyl limited edition I ordered. Thanks. | |
| Time to blast off from Rhea If you like the Spectral phono get a SUT for the LOMC and call it good. | |
| Time to blast off from Rhea If you do not want to deal with tubes in your phono preamp, I recommend you look for a Klyne phono preamp instead of the Parasound JC-3. Superb build quality and very quiet.If you want a John Curl design you could look for a Vendetta phono preamp.... | |
| Time to blast off from Rhea I think the Herron and am sure the Audio Research phono stages use a FET front end for the additional MC gain. | |
| Time to blast off from Rhea An all tube phono preamp amplifying a LOMC, and using high efficiency speakers is probably going to have some tube rush. I have 2 suggestions for you. Talk to Andy at Vintage Tube Services, if you have not already done so; and try a SUT, maybe Bob... | |
| Which tonearm with a Soundsmith The Voice? Go to the vinylengine Cartridge Resonance Evaluator, and enter "11" in the box where it says "effective mass", then look at the table that is produced.That should help you with a general idea. | |
| Which tonearm with a Soundsmith The Voice? I saw a used Schroder #2 9" arm with a Pertinax armwand for sale, but unfortunately not on Audiogon. | |
| Need some suggestions for a new audio rack I found a table that worked for my office system for under $200. Take a look at the system. I think I found it on Wayfair or Amazon. Danger - Not audiophile approved, so it was a lot less expensive than one with the seal of approval. | |
| Basis Audio Super Arm 9 Thanks for the information. I will start putting money in the piggy bank. | |
| Which tonearm with a Soundsmith The Voice? You may want to also ask your question at audioasylum or vinylengine. Only 3 posted systems here have a Soundsmith The Voice cartridge. | |
| Which tonearm with a Soundsmith The Voice? The entry level Schroeder model (No.2) has 11 gram effective mass which should work with your 22 compliance Soundsmith Voice according to the calculator on vinylengine.com, which indicated a 5 - 11 gram tonearm effective mass is the range based on... | |
| Cartridge or cable upgrade A good SUT may cost more than your turntable. I would get a MM or HOMC cartridge for now.http://www.bobsdevices.com | |
| Basis Audio Super Arm 9 That is exciting. Could you write a few words comparing it to the Vector 4 tonearm.I had a Basis 2000 turntable with a Rega tonearm, it was a revelation, and major improvement, when I replaced the Rega with a Basis Vector 3. |