hifitime
Responses from hifitime
World's best Pre-amp for $10K and above? Again, all the best designs all have S/N ratio's above 125 db's.08-13-12: AudiozenEvery time I see a statement like this, the first thing that comes to mind is, "A fool and his money are soon parted." I used to be a spec person. Then I discovered ... | |
A change of speaker impedance; is it possible? You could add a large non-inductive resistor, with proper (high enough) wattage handling in parallel, with the speaker input. That would help lower the impedance. One of the results will be a lot of power wasted, as the resistor will be changing t... | |
Unusual TAS bomb I like to read the reviews. When they do tell you about the equipment's flaws, it's usually even worse in your own system. So they do save me time and money occasionally. But, when they tell you it sounds fantastic, don't believe it until you've h... | |
Another cheater plug thread Yes Rodman. In 1951, the laundry outlet was required to be grounded. Then in 1962, all outlets were required to be grounded as you stated. That shows the grounding requirement must have shown an improvement, towards people dying from electrocution... | |
Another cheater plug thread If you use a cheater plug, or disconnect the ground in the preamp, it will not be considered grounded. There is always a possibility of some kind of failure happening. With a preamp, the power switch alone is a risk. Lose connection somewhere in i... | |
World's best Pre-amp for $10K and above? Audiozen, now your recommending these "warm, lush, and laid-back tubes," as the sound you prefer. Sounds like your chasing your tail... | |
MM Vs MC Your Sumiko Blupoint Evo III, is a high-output moving coil cartridge. That means you can run it into a moving magnet phono preamp. Regular moving coil cartridges are low-output. These need extra gain. If your phono preamp doesn't have the capabili... | |
World's best Pre-amp for $10K and above? Why use Aerial Acoustics 7T speakers? Those cost about $10k a pair. Did you forget about the Polk speakers in this thread? They're about $6k less, and will probably (according to your description) sound better yet! For less money! Wow!!!What next,... | |
Strangest problem I've ever had To add more fun, and headaches to it, it sounds like Quietrock 530 has metal inside it. It's under "cutting the panel" on page one. I saw this on a home improvement type of TV show. | |
4 ohm or 8 ohm tap on old tube amps? 07-22-12: RrogHifitime, KT88's post sounds impressive, however, VTL and Manley Labs have always provided only one output on their amplifiers set at approximately 5.5 ohms for the best sound with the majority of speakers. Yes, they did it by choice... | |
4 ohm or 8 ohm tap on old tube amps? I think user name KT88 gives an idea of what happens in this other thread. | |
Best way to run in your Cable Elevators? Must be getting boring ɹǝpun uʍop again. | |
Best Methods For Removing Dust From Drivers...? Gravity. | |
Anyone know what these funky vintage speaker are? They do look like the Eico HFS-2 in the links provided by Kr4. | |
The finest Cable Elevators you ever auditioned? Just consult these experts, or whoeverdesigned this setup. |