angelgz2
Responses from angelgz2
| Parasound Halo A52 keeps shutting off / protection Hi thanks for the advice. I'm using all 5 Channel, the MLs are bi wired plus an extra sub. I have an external fan and when I touch the unit it's not very hot. For some reason one side does feel hotter than the other. | |
| Increase total Speaker Impedance Question Hi Bill and Al, I would like to thank you for all your invaluable inputs. After thorough testing, I cannot tell a difference (besides loudness) between using a 3 ohm resistor vs splitting the speakers (tri-wiring). Therefore, I would like to say t... | |
| Increase total Speaker Impedance Question I'm thinking something like the Henry Engineering PatchBox II Stereo Output Multiplier may work. It's got a balanced input with multiple balanced and unbalanced outputs. If that works it actually solves all the problems. | |
| Increase total Speaker Impedance Question Hi Al and Bill,Thanks again for all your inputs. Once the resistors arrive, I'll let you know how it goes. A challenge with using multiple amps for a speaker is that the pre-out connection on the pre-amp cannot be split. If I use a splitter, i.e. ... | |
| Increase total Speaker Impedance Question Thanks again Bill and Al,So in short, there's no way to rectify my current situation with a resistor. Is there possible to redesign a 4 way crossover so that the speakers can be wired as a series or series-parallel? Or, as a last resort, to use se... | |
| Increase total Speaker Impedance Question Hi Bill and Almarg,Thanks again for your detailed explanation. I understand the power loss in this setup. However, I am still having difficulty grasping why the sound quality would also take a turn for the worse. Will the frequencies be improperly... | |
| Increase total Speaker Impedance Question By the way the receiver is rated at 125 watt each channel, so 200 watt resistor should be sufficient? | |
| Increase total Speaker Impedance Question Thank you all for your response and help. Yes, all of the speakers are different models and hence each have its own unique crossover that I ordered from Parts Express. As a results the only way to make it sonically plausible is to wire them in a p... | |
| Different subwoofer at each corner? I see. Thank you all for the great suggestions. I'll start off by lowering the crossover point to 80hz to see if that helps. I'll play around with the phase settings too.Thanks! | |
| Different subwoofer at each corner? I see, thanks for the input. So the fact that they are not identical does not pose a problem? PS, they are crossed over at approximately 100hz. | |
| Is Monster cable getting better? I've recently dissected a few newer models from Monster Cables, the iCable, the HD1000 and some ICs. My findings are the following:1. Poor quality copper, noticeably lighter and less dense. When you touch them they don't feel like metal at all.2. ... | |
| I got the USB DAC per everyone's sugguestion BUT.. I see. Thanks for all your suggestion. All the brand names mentioned here, did you guys actually tried it and confirmed that it will work at 24/96 in Windows 7?Anyways, after weeks of trying, I finally got the V-DAC to work at 24/192. These are my... | |
| The best speaker you ever heard? Dynaudio Sapphire. Doesn't matter who says I swear by the Dyns although this particular one is not as costly as some of the names mentioned here. Unfortunately, my pockets aren't deep enough to go beyond that. I am sure the Evidence Master would s... |