2. amps-preamps
  3. 1373954193

Volume control for power amp


Hi and thanks for reading this post.

I have a 3-way active set up at the moment with one amp driving the tweeters, another amp driving the bass units and a quad 405-3 power amp driving the mids.

The problem is that there is too much midrange information coming through the speakers and with the quad being a power amp only there is no volume control to adjust the sensitviity.

I am thinking of soldering a resistor across the positive and negative terminals of the phono input (screened cable) of the quad in an attempt to lower the volume a little.

Do you think this is a good idea, if so what value resistor should i use.

Many thanks in advance. John.
goodsguys
atmasphere's avatar
atmasphere
11,640 posts
 
I would install an actual volume control so you can get the setting exactly right.

I would use a 100K potentiometer for this task, especially if you plan to use a tube preamp or crossover.
marakanetz's avatar
marakanetz
5,473 posts
 
you can find Rothwell 20dB, 10dB fixed value attenuator for that purpose. all you need to provide in your post is sentitivities of all of your amps and gain.
swampwalker's avatar
swampwalker
5,138 posts
 
Ideally, a 3 way active crossover is required to get the proper balance btwn all three frequency ranges.
rrog
1,958 posts
 
All amplifiers should be the same.
More to discover