Need suggestion on tube amplifier with XLR inputs


I am looking for a two channel tube amplifier (not sure of the wattage I will need as I am not 100% sure how the wattage correlates to transistor wattage so I will need a recommendation on this as well). My current set up is as follows: Emotiva DMC-1 Pre-amp/processor, Behringer cross-over, Emotiva XPA-5 (5 channel amplifier) and a Krell KSA-250 (2 channel amplifier) I have them connected via XLR cables throughout. I use the Krell to power my two JL-Audio 13W7 subs. I use the XPA-5 to run all other speakers at this time. What I would like to do is purchase a 2 channel Tube amplifier to run my center channel speakers as these are responsible for most of the mids/highs and use the 5 channel XPA-5 to run the surround speakers. My thought is that the center is responsible for most of the sound in a 5.2 system anyway so if I were to put my money on adding quality sound this would be the spot to do it. I need a two channel as I would like to run my tweeter on a separate channel then the mids so as to isolate each signal through the cross-over to have more granularities in tuning each of them. My tweeter has a speaker efficiency of 106 db and my mids are 87 db. If I run them through the same channel the tweeter will obviously overwhelm the mids and does as I have tried this already. So my question is, what 2 channel tube amp would you recommend that would drive 3 4” midrange drivers on one channel and then on the other drive 2 tweeters? I think I need something that would equal around 200 transistor type watts per channel as that is what the other surround speakers have running to them. I thank you in advance for any and all advice!

P.S. I would like to keep the cost under $3000 and am perfectly fine with purchasing used equipment. Thanks again!
ectomorph81
BAT VK-60. Could probably pick one up for around $1,750 used. If it turns out that you need more power, it can easily be bridged to 120 watts. You would then, of course, need another amp for the tweeter, but a smaller amp, about 2 watts, ought to take care it.
Thank you all for your replies! In regards to J_bailey's suggestion I have been doing some thinking and being that the speakers that I am going with have a large difference in their efficiency would it be a better/smarter idea to go with 3 different amps for my situation? Have low power amp for the tweeter (SPL: 109 dB 1W/1m) , a more powerful amp for the mids (SPL: 86 dB 1W/1m) and then of course the ridiculously powerful Krell for my subs? Let me know your thoughts and thanks again for the replies guys!!
It sounds like you might be in over your head. Wouldn't a simpler system result in a better sound? That has been my experience.