Distortion with ARC Ref 150 and Maggie 3.7


I have this problem that drive me nuts for quite a while. I purchased a like new fully balanced ARC Ref 150 tubes amp through Audiogon for my single ended only CAT SL1 Ultimate preamp and connected both with a RCA to XLR interconnect. It sounded okay with most recording but has awful distortion with certain recording specifically piano and vocal. Some of this recording happens almost on entire record but some only on certain musical passage. Most of the time with higher pitch or peak of music or higher volume.

For your information I listen to vinyl only most of the time and more on Jazz music. Other component listed as follow:

Turntable: Sota Nova, Tonearm: Origin Live Illustrious, Cartridge: Dynavector XV1-S, Step up transformer: Bob's Device CineMag 1131 (Blue) feeding directly to CAT's own phonostage, Speaker: Magneplanar Magnepan 3.7. Power cords, ICs, Speaker cable, Autoformer: Paul Speltz Anti-Cable.

Trouble shooting which has been done includes: checking preamp tubes condition and checking power amp bias. Since ARC claims their Ref 150 was design for balanced preamp only so I also tested by replacing it with single ended tubes amp but the distortion remain. As for the cartridge I believe I have done the alignment pretty accurate with the Mint's Best Tractor but not very sure with the azimuth.

While tested with my other 2 pair of speakers, one which has higher spec show the same problem while the lower spec one seems get rid of distortion. So I suspected the issue probably was with the new Maggie. Called the dealer and he performed a test with his transistor amp with no distortion at all. So he assumed my Maggie is okay. Is it true that the Maggie only good with transistor amps?

By now it leaves me with total confusion! Sincerely hope fellow audiophile here could give me some advice and save me from this endless misery !

Thanks very much in advance!
pakwong
Do you have the Bob's devices SUT into the MC or the MM input on your CAT pre?
There are plenty of people that drive Maggies with tube amps. I agree that tube microphonics would explain what you are hearing, and it is pretty easy to address. Also, the fact that you tried two other speakers, one of which gave you the same result, probably means it is not the Maggies per se. However, because they are dipoles, they may direct more energy back to the tubes. Just wondering, the other speakers you tried--- were they both rear ported? If the one that didn't give you distortion is front or bottom ported, or sealed, that could also be a clue.

On the other hand, I had no such problem with my 3.7s with my Coincident Line stage preamp, which uses highly microphonic 101D tubes, and had no problems, although I do use tube dampeners.

It might also be worth switching out the speaker wires and ICs if you have spares. A weak connection at the terminal can give intermittent distortion problems.
Can you borrow a digital source (CD player) and play the same recording to see if you can identify the same distortion as with your analog source. If no apparent distortion, the problem may be with your tonearm/cartridge alignment.
Somewhat odd that only some recordings and/or passages of same are sound distorted. Could very well be your SUT or cartridge or alignment.
Good luck!!
I own a pair of Maggie 3.7's but I run them with a SS amp.
I have no idea what the problem is but was just wondering if you ever tried using the resistors with the Maggies and if that would correct any of your issues?
From what you describe, I think that maybe you are overloading the phono input. Make sure you are using the MM input and not the MC. If you are using the MC along with the SUT, it could very well indeed be too much gain.