Sweet Spot for Triangle Speakers


Has anyone had any experience with the new Triangle Zerius Speakers? I have a pair hooked up to an Outlaw Receiver and the "Sweet Spot" is very small. With my old system I could sit almost anywhere in the room and the illusion was intact. With the Zerius if your not in the middle/spot you hear the speakers. In the reviews the Triangle speakers have been often compared to electrostatic speakers...and one thing I have always heard about electrostatic speakers is the problems with their placement. Is there a way to place the speakers such that it minimizes this effect or will this get better as the speakers continue to break in? Thanks for your time and input.
patriot
The Outlaw 1050 is a HT receiver...has a small cult following on the internet. For the money ($499) it is one of the better units.

My old setup included PSB Golds, Hafler 500 and a CJ PV-2A. I appreciate your feedback and suggestions. I need to play with the placement/room (24X24).

Again, thanks.
The best description for speaker placement that I have read is on the audiophysic web page:
http://www.audiophysic.de/produkte/aufstellung/aufstellung_e2.html
have a read and see if it works for you. I also like the cardas placement method. I have never heard good imaging with speakers close to side or rear walls. I also like nearfield listening.
I have the Triangle Antals and had a similar problem until I did the following:

1. Since the Antals are used for music and home theater they have a 65" Rear Projection TV between them. I inferred by the fact that you have these hooked up to a home theater receiver that you may have a TV between them. If possible, move them out so the front of the speaker is in front of your TV or cabinet (still on the sides but further out). This will help image focus.

2. Play with toe-in. Toeing them in will focus the image, firing straight ahead will widen the soundstage. I find my Antals sound best fired straight ahead with no toe-in.

3. Try different cables. This made a huge difference. I switched from Kimber 4TC to Mapleshade Golden Helix and it made a huge difference.

4. Use a room tuning device. I use Echobusters behind each speaker. There are also a bunch of DIY recipes (check www.audioasylum.com) for similar

As mentioned I use the Antals for 2 channel as well as home theater. I'm using a Rotel 1066 processor and 985 Amp (5 channel)with MIT interconnects and Mapleshade speaker cables. These brands go very well with Triangle gear (I've tried everything). Good luck.
Patriot, your room dimension is a nightmare - a perfect square is the LAST thing one wants to deal with in setting up speakers. DO check out the Cardas website, and also search the Stereophile site for the Room Tunes articles from a few years ago - I forget who wrote them, but they are there and very good. You more than likely have standing waves all over the place, reinforcing a host of lower pitches, so I would imagine that you will need as another poster pointed out some DIY absorbtion devices. These will be the most imp upgrade you can make barring none, esp given the dimensions of your room.