$10 / foot speaker wire


I'm looking for decent speaker wire for about $10/ft. I've ruled out Analysis Plus (tizzy, Kimer (bright), Goertz and braided high capacitance designs. Looking at:
* DH Labs Q10
* Mapleshade clearview golden double helix.
* Audioquest Type 6 from Audio Advisor.
* Luminous Audio Technology (LAT) spiral wrapped 18 gauge.

Are any of these any good for transparent, neutral sound? Is there something better?

Thanks
cdc
Thanks for the suggestions. I will be putting them on my list to look into. Definitely a sale priced AQ looks worth trying.
second the canare star quad. .69cents a foot at marketek.com and they will terminate.
RED ROSE 336 cable at $10/ ft. is THE cable to own in this range. I heard them in the NY studio and was extremely impressed with the system. I would definitely look into these.
CDC:

Did you ever try the magnet wire?

I just finished a set of speaker cables which are single runs of Chimera Labs 25.5 gauge magent wire running through 18 gauge Teflon tubing. The wire was inexpensive (purchased a 100 ft. roll) and the Teflon tubing was under $10 (@ Fryes Electronics) for a 35 ft. roll.

They sound very nice (not quite as good as the 47 Labs OTA, but still in the same ballpark).

I also made an IC from the Chimera wire (CD player to preamp) which I am breaking in right now. The IC is a simple single run "nude" design. RCA's are Radio Shack (8 for $2.99) that have had their metal mass further reduced (cut off the strain relief tab and part of the outer metal housing which makes contact with the outside of the female RCA). An additional treatment is to polish and clean the contact areas of the RCA's. A lot of work, but it goes fairly quickly once you do a few.

The Chimera wire is a bit difficult to work with if you do not own a solder pot (I don't), but I was still able to achieve good results by stripping it with a butane lighter, polishing/cleaning the bare surface and then tinning the same with Chimera Labs solder. To be on the safe side I wrapped the ends of the wires (in the area where the insulation and the tinned surface join) with Teflon plumbers tape in the event that the coating was not completely intact in the transition area.
I have some Luminous Audio Renaissance speaker cable in a true bi-wire set-up & for the price it's hard to beat. Instead of going into details, I'll just list my review>
http://www.audioasylum.com/audio/cables/messages/44584.html
>if you'd care to read it, although there have been changes to my system since my review.