Which Tonearm to go for VPI HW-19 III?

I hear that the Eminent Technology arm is a great fit. I have the ET2 arm on another table and believe it is the best turntable to support this arm.
I strongly suggest you investigate this option.

I agree with Scott and Ed, the mk IV upgrade is well worth it. If you want to take it further, you can add the Stand Alone Motor Assembly (SAMA) and Synchronous Drive System (SDS). That takes the HW-19 concept about as far as it can go, which is pretty far indeed. I'm happy using the JMW 10.5 tonearm with my full blown HW-19 setup. I never tried the Rega RB-900, so I cannot compare. I did originally have a RB-300 and I'm much happier with the sound of the 10.5 tonearm.
The mk IV upgrade is the first place to start though.

Regards,
John

Thank you all for the valuable inputs. If I decide to upgrade to IV, should I contact local VPI dealer or talk to VPI directly? and how much will be?
I saw an ad here at audiogon from discovery cable for rewiring services for RB300. Have you all compare different rewiring products? How does the rewired RB300 compare to RB900?

Thanks,

Steve

Steve, many of the dealers of cartridges and turntables, (Elusive Disc, Acoustic Sounds, Audio Advisor, Etc,) will carry the MkIV upgrade. It can also be ordered from VPI directly. I can tell you that VPI is really backed up and presently the Aries Black Night platters are in very short supply, if at all. You would probably be looking at about 3-4 weeks for delivery.

I believe that the MkIV upgrade (platter, bearing and suspension) is about $600.00+, the drilled Super armboard (1" thick) about $100.00+.

The RB900 arm is factory supplied with a better quality tonearm cable than the factory 300 arm. I don't know any details on that specific wire. There are many different manufacturers of Rega upgrade cables. I can tell you that my upgrade cable is by Incognito, and the actual wire is Cardas Litz. ANY good quality upgrade cable will work wonders for your RB300.

A fully modified, rewired RB300 is sonically, a completely different tonearm than the factory RB300 tonearm. Quite frankly, it is within spitting distance of the RB900 arm and then some. But, that's comparing to a fully modified RB300 including rewire, weight, endstub, VTA adjuster, and maybe even the TWL mod.

My opinion? Go for the MkIV upgrade first. It will put that turntable in a whole nother' league. And you can sell the existing MkIII platter and bearing here on Audiogon to offset the cost of the upgrade.

Check out this link and scroll down to MkIV upgrades:

http://www.vpiindustries.com/upgrades.htm#hw19parts

Have fun, Ed.

Steve,
I would deal with VPI directly. I've found that to be a more direct route. As for the Discovery cable, many tonearms come wired with Discovery cable. All VPI JMW arms are wired with Discovery, as are the Wheaton arms (Tri-Planar). There are a couple other tonearm manufacturers, but I can't remember them right now. I liked my VPI JMW 10.5 so much I tried a 1 meter length of Discovery Essence between the arm and the phono stage. It was a big improvement over the more expensive Phono cable from Transparent Audio that I had been using. So this is something that may interest you, after the mk IV upgrade of course.

Regards,
John