vpi jmw tonarm rust yes rust

I hope I didn't offend anyone here. My intentions where certainly not to "slam" VPI. I brought this up to see if anyone else possibly had a similar problem, and possibly to warn them.

The web site says the arm is stainless steel. Again I suggest calling VPI. They are very very helpful.

Just a note,there are many grades of stainless steel.The higher the grade# the better.Lower grade#s will rust,Surfice rust only.Higher grade#s do not .Just try [Theo]`s idea, the wd40 will more than likely remove it.It is only on the surfice.Is your equiptment located in a high humidity area?If your sound room is in a basement you may want to check the humidity level.You may be slowly getting rust inside your audio equiptment.You may have to install a dehumidifier.Just so I don`t get yelled at,I am not saying VPI is using cheap SS.The grade they are using I am sure they have a reason.Ask them.

no rust here, but the damping oil for the jmw arm attracted some (desparate) ants- quite a few of them. i got rid of the oil and rubbed a little black flag on my precious plinth!
i hope this doesn't screw up the sound too much...
i don't want to be the science teacher here, but metal corrodes in the repeated presence of liquids - perhaps used in the record-cleaning routine of certain persons...

I would be more concerned about the chemicals in the Black Flag you rubbed on the the plinth of your VPI.Have you read what`s in there.