Audio Magic Pulse Gen products

Thanks for the additional postings. A liitle more information...

While I was waiting for the Pulse Gen's and another P4 HiDiamond Power cord to arrive I took out all of interconnects, power cables, etc. and re-cooked them on my Audiodharma Cable cooker.

After installing the Pulse Gens in the equipment, I re- connected all of the cables, including the recently acquired and now recently cooked HiDiamond P4 power cord. The HiDiamond P4 power cord is very thick and still will take along time to fully break in.

The first day with the Pulse Gen's connected the music sounded a little sharp , but today 2 days later, the sound is settling in nicely with a very wide soundstage.

Ozzy, good to hear things are settling in a bit. Keep us posted.

Emoonie, how much info did you get from Jerry on the PEA's? I take it the three sizes vary with respect to the size of the field. If that is correct, do you know how large of a field each size creates? I could perhaps use 4 minis plus maybe one medium to place above my Mini Ref II and between the pre amp and its power supply. Or, if the field of the medium size is big enough, I might be better served to buy two medium size PEAs to go with each of my monoblocks, and perhaps the field would extend to the crossovers on my Maggies.

Brownsfan, I was told the smallest PEAs were a quarter strength of the medium ones. They'd suffice nicely inside components and would be complimentary to the Pulse Gens. He suggested two mediums to start and try them behind the speakers. I regularly find his suggestions are spot on. Haven't tried them anywhere else in my rig as I'm enamored with their effect but did move them around a friend's in other positions because his are actively tri-amped and my preferred spot(so far in my system)is not readily available. Sounded best on top of his DAC/transport by far. Settled (charged?)from twenty seconds to about five minutes. Didn't seem to be noticeably effective on the phonostage, linestage, by his ICs into the speakers or the AC cords into the speakers. From my very limited experience I'd recommend two medium ones and place them on the X-over @ the speaker wire side. Then again here my amps are underneath the eight inch tall X-overs so perhaps the field permeates to them also. Nice thing is with them being self powered moving them around and back is a snap. Hope this helps.

Emoonie, Thanks. That is helpful. If the mediums have 4 x the field strength of the minis, I'm guessing that means 2 x the range. Assuming a mini probably has at least 18 inches of range, I should be able to place a medium on top of each monoblock and have the field extend to the crossovers.
I'm still waiting to hear back from Jerry, but the info you provided is a good start. I have also found Jerry's recommendations on target, but I am thinking one mini, one medium, and two pulse gens would allow me to fully assess where I am going to see improvements.

I just ordered 3 of the PEA standard units. Jerry said these work well with the pulse gen. I'm very pleased with the Pulse Gens so hope he's right on.

Emoonie, I thought the PEA were made to go on components, but you say they work well behind speakers, please explain.

I wonder what will happen when I place one on top of my PS Audio P10 power regenerator.