2. cables
  3. 1201464328

Best Speaker Cable Terminations

I recently purchased a Krell KAV-400xi and a pair of Proac Tablette Reference 8 Signature loudspeakers. I'm making my own speaker cable and will use a single cable with four 10 gauge wires inside of it, for bi-wiring.

I'm going to terminate the cable with spade connectors on the speaker end and was planning to twist the ends together for connection to the binding posts on my Krell. Now I'm wondering if four 10 gauge wires, twisted together, would even fit in my Krell binding posts.

Any ideas on the best way to do this?
worldwide
audiophile36
17 posts
 
use spades all the way around would be the best IMO.
cpk
190 posts
 
My suggestion would be try to put spades all around if possible. Bare wire oxidizes and will fatigue from being clamped on.
porziob
316 posts
 
One could make a case for locking banana plugs.
worldwide OP
58 posts
 
My main concern was fitting four 10 gauge wires into a single spade. Maybe I should go with two spades and two banana plugs. That would give me two wires soldered into each termianation?
carl109
134 posts
 
I'd do my best to fit the cable straight into the binding posts if possible; the less connections the better.

It's true copper oxidises, but this happens slowly on the exposed copper (not the bit clamped inside the post), and it's nothing that can't be fixed by trimming an inch off once a year.

I noticed what to me sounded like more open upper frequencies (especially in some vocals) when I eliminated the banana plugs and went to bare cable a while back.
More to discover