VPI Aries with non-VPI arm

Anyone using a Tri-Planar or Kuzma 4 point on a VPI table?

Maxh, I used a Tri-planar VII on an Aries 2. Worked fine. It looked a bit odd since I had to use the same spot where the longer jwm 10.5 was mounted. The arm board was in a fixed spot. The result was that the arm at rest sat at an angle instead of pointing straight out. But I was able to get the right pivot to spindle distance so it worked fine. That would be less of an issue if the arm was of similar length to the 10.5 instead of being a 9 inch arm.

BTW I bought an extra arm mount board or "puck" on Audiogon that I drilled for the Tri so I could keep the original arm board free of extra holes. Spacers were also needed to raze the arm up from the arm board.

...just wondering....do you not like your 3D arm?