2. analog
  3. 1323625812

Strange low frequency noise when playing vinyl.

I'm getting a strange low frequency noise when playing vinyl that I did not notice until a month or so ago. My turntable is a Scoutmaster with JMW9 tonearm. I've included a link to a recording I made of the noise. I used the locked inner groove of an LP and removed the belt from the motor and spun the platter by hand. As you will hear, the noise will change with the speed of the LP. I have tried the following the remove the noise: Two different cartridges by different manufactures; outer ring, no outer ring. Clamp, no clamp, two different phono stages. Only possibilities I can think of is bearing noise or resonance of the tonearm.

Link: http://www.mediafire.com/?iski6xsvdsbwbq7

You may need to turn your speakers up to hear the noise.
A_L
arnold_layne
ghost_rider
117 posts
 
I can not play flac files on my Mac, it may be better to upload with video to utube so we can help you out.
arnold_layne OP
141 posts
 
It's not video. It's an audio file. There's no way I could capture the low level hum with my camcorder. I used FLAC to encode the audio to make a smaller lossless audio file. You can download VLC for Mac that will play FLAC files.

A_L
sarcher30
596 posts
 
I can think of two possible causes.

First I would pull the platter off and examine the bearing. If you did not assemble the table yourself pull the platter straight up and it should come right off. Vpi recommends that you relube it once a year. You can buy the lube from Vpi directly or just buy some white lithium grease. Wipe off the old gease and put a good dallop on the top of the bearing. Then carefully replace the patter.

If that does not help it may be noise from the motor getting into the plinth. I once had a scout that had this problem. I solved it by completely isolating the motor from the shelf the tuntable was on. I acompished that by having a sandbox under the turntable stand. Then I attached a 2x6 to the outside of the sandbox. I then fabricated a flat piece of steel to go on top of the 2x6 to support the motor. The turntable was really quiet after that.

If you find that it is the motor and you bought it new I would ask for a new motor.

I now have a Vpi Classic and hear no noise from the motor at all. I may have had a defective motor on the Scout.

Sean
More to discover