Turntable cones/spikes or shock absorbing feet?


How about both?

I've dorked around with my turntable (SL1210) feet various ways over the two years. Recently I tried something that turned into a real keeper:

I had been using the Parts-Express solid brass Dayton speaker cones as the threads fit the Technics. They were seated directly on a butcher block turntable and were noticeably better than what I'd had before.

What I tried was taking a set of "floor savers"--those flat metal discs with an indentation in the center for protecting floors and shelves from spikes--and placing the cone points on the floor savers, and placed the floor savers on top of a set of weight-matched Vibrapods.

Voila! This made everything better--no tradeoffs. Lower noise floor, better imaging, better dynamics at both ends, better inner detail.

The problem is that it's hard to come across floor savers of sufficient diameter to perch on the suspension doughnut of the Vibrapod.

But there's another way: Herbie's (maker of the Way Excellent TT mats) makes these cone/spike grounding bases, which combine floor savers of various sizes with an underlayer of his dBNeutralizer(tm) pad.

The Vibrapod website also mentions this type of arrangement, but as I said, the challenge is finding a floorsaver big enough to use with Vibrpods.
johnnyb53
I use gel wrist pads ALONG with the original leveling feet on my turntable.
Where have you positioned the gel wrist pads?
4 racquetballs and 4 caster cups. Place the racquetballs in the caster cups. Unscrew the 4 stock feet from the Technics. Situate the caster cups / racquetballs on the tabletop / shelf / whatever so that the Technics rests on the caster cup / racquetballs in place of the stock feet. This combo provides some of the benefits of a sprung design with the virtues mass and damping inherent in the Technics. Its cheap - much cheaper than Ginko Clouds - and pretty darn effective. I found some nice looking wooden caster cups with rubber on the bottom that make a very nice overall presentation as well.
Johnb53,

Gel wrist pads under each of the four turntable feet.
Thanks for the tip.

Regards.
I ordered http://www.oregondv.com/15spike.htm spikes from Oregondv . com, they custom did some 2.15" spikes in black chrome for for my Salamander Berlin Rack which have worked wonders... Very attractive.. I ordered the 1.5" M6 threaded in black chrome for my Technics.. I'll use the washer method underneath to level the spikes correctly and provide better mounting. 4 - 3/4" 2 1/4 diameter 1/8" washers to prevent foot swaying or or fender washers 2" with 1/4" whole in center (based on threads I researched) and this will be on top of a 1" acrylic support which I might float on Aurio Pro Max's if I don't get the results I'm looking for.

My friend uses the larger Mapleshade brass footers M6 threaded into a 3 or 4" Maple plank on top of the Mapleshade Isoblocks. the improvement was dramatic compared to the stock footers.
It all depends on the table/setup. With a Rega, I found that great benefit can be had by using inverted cones under the surround. With my VPI Superscoutmaster Ref. rim drive, I find that using maple butcher block is the best thing to use. Experimentation will reveal it all.