2. speakers
  3. 185674-154981

Klipsch Cornwall IVs KC62 and yamaha AS2200 setup questions

First off. Thanks

1. The yamaha has pre-out and line out choice. Which do I use? The manual says Pre-out

2. Cornwall is rated down to 34hz where should I set the KC62 crossover? Currently I have it set to 50hz

3. Ive noticed when i use pre-out there is very little sound coming out of the sub. Even with the sub at max volume. If I use Line out there can be a ton of volume but I have to volume match the sub manually every time i change the amplifiers volume. As you can probably tell Im a new to this subwoofer stuff.

4 KC62 has a High pass filter dongle. do i need to use that?

Again thanks in advance

paqua123
musiclover1's avatar
musiclover1
49 posts
 

Try connecting via the speaker connection on the sub ( presuming it has one). Then set the volume on the sub to integrate with your Cornwall's. Should give you good results.

Cheers.....

paqua123 OP
48 posts
 

It does have speaker terminals.  So use speaker B terminals or use the same one as the loudspeakers?

musiclover1's avatar
musiclover1
49 posts
 

On the back of your sub it should indicate "speaker level input". Connect speaker wire there and on the other end, to your main speakers.

So you will end up with one set of speaker wires connected to your amp, ( which is also connected to your main full range speaker) and the other set connected to your subwoofer which is also connected to your main speaker.

paqua123 OP
48 posts
 

I have one KC62. Would i have to run wires from both main speakers to the KC62 or just one ? 

paqua123 OP
48 posts
 

Also, The AS2200 as A and B speakers and you can play both A and B speakers in its bi-wire selected mode?  So could i feasibly connect the sub to B speaker and select and b to play or is it just better to run in series from the main speakers?

More to discover