2. speakers
  3. 185674-154981

Klipsch Cornwall IVs KC62 and yamaha AS2200 setup questions

First off. Thanks

1. The yamaha has pre-out and line out choice. Which do I use? The manual says Pre-out

2. Cornwall is rated down to 34hz where should I set the KC62 crossover? Currently I have it set to 50hz

3. Ive noticed when i use pre-out there is very little sound coming out of the sub. Even with the sub at max volume. If I use Line out there can be a ton of volume but I have to volume match the sub manually every time i change the amplifiers volume. As you can probably tell Im a new to this subwoofer stuff.

4 KC62 has a High pass filter dongle. do i need to use that?

Again thanks in advance

paqua123

Showing 4 responses by paqua123

paqua123 OP
48 posts
 

I have one KC62. Would i have to run wires from both main speakers to the KC62 or just one ? 

paqua123 OP
48 posts
 

Thanks for the reply. It may be my room but the bass hasnt been stellar on the cornwalls. Is it clean yes, articulate yes. But it fails to reach deeply on songs like Aquamarine by Santana. I ran the speakers for months prior to buying the sub. 

I put the sub into manual mode and have it set around 1 o'clock. 

When i plugged the sub into Line out from the amp, the amount of bass produced was huge...the volume control on the sub seemed to be far more active. Big issue there is you have to volume match. I have the speakers direct wired to the amp..the sub is connected to Line out or pre-out on the amp not via speaker connection

paqua123 OP
48 posts
 

It does have speaker terminals.  So use speaker B terminals or use the same one as the loudspeakers?

paqua123 OP
48 posts
 

Also, The AS2200 as A and B speakers and you can play both A and B speakers in its bi-wire selected mode?  So could i feasibly connect the sub to B speaker and select and b to play or is it just better to run in series from the main speakers?

More to discover