lumin direct to "main in" section on Yamahas/Luxmans/Accuphase?


I have a Yamaha s3000 on loan from a friend, noticed some of these Japanese integrateds like to insert a "main in " section next to the pre-outs as well as two sets of binding posts to drive two speakers

I would like to connect my lumin d2 direct to this "main in" input and bypass the preamp section of the yamaha

worried about causing issues

can anybody confirm if this is safe to do?

 

 

audiocanada

The the OP as you travel on your audio journey do yourself a favor and try running the D2 USB out into a nice R2R DAC and into a tube integrated amp. You do not know what you are missing.

As a Lumin D2 owner (in the box up for sale) I can tell you that the internal DAC is a little harsh sounding with many amps and running it straight into a power amp is not going to sound the best.

But to each his own. I have gotten to the point where I cannot even listen to solid state anything anymore without getting very angry and smashing the speakers....😀

Just make sure you have the Lumin's Leedh volume control activated (variable output) and start on the lowest level setting to be safe. Using a good preamp sounds better to many listeners, but there should be no problem in using the Lumin's variable output into an amplifier directly.

But to each his own. I have gotten to the point where I cannot even listen to solid state anything anymore without getting very angry and smashing the speakers....😀

 

Umm... I’m not sure if that’s the fault of solid-state amplifiers. Harshness can be associated with many things - speakers, amp-speaker interface, source or room, or a combination of any.