On that note; I have been waiting for this to come up, I live in SoCal in the SDG&E jurisdiction just by the way. I have never had a type AB Amp that didn't buzz and now I have a type D that is quiet as as a a night full of stars for no apparent difference in set up. I also had an old beach house that would cause my Krell 2250 to Buzz Loud when it was off when the Mr. Coffee came on in the kitchen. good Morning sunshine. THAT SYSTEM CONSISTENTLY BLEW DRIVERS AND EVENTUALLY FRIED THE POWER CONDITIONER DURING A T- STORM. Some of this hi-end equipment is touchier than the Manufactures would have us layman believe. peace out
Low buzzing through speaks
Hello All,
Need some serious help here. So I just (upgraded?) from a Marantz AV8802A to a McIntosh MX122 preamp. I also just got brand new Revel Performa3 speaks all around (5 channel setup). I disconnect everything from the Marantz and then into the McIntosh, connect the speaks and I have a faint buzzing through all 5 speakers (that was not there previously). I have everything plugged into a Furman Elite 20pfi power conditioner which is plugged into a dedicated 20 amp circuit. My power amp is a Simaudio Titan HT200 5 channel. This is not going through the Furman but directly into the other outlet on the same 20 amp line. I even tried plugging the Sim amp into the Furman to see if that helped-no change faint buzz is still there. I have unplugged just about everything, and the buzz is still there. It is very faint and does not get louder when I turn up the volume. Again it is faint and you have to put your ear up to the speaks to hear but it is definitely there. I have tried so many things and nothing gets rid of it. It is not my cable box (I did have that issue previously with the Marantz but as soon as I unplugged the coax from the box it went away so I just bought a coax loop eliminator connected the cable to that and noise was all gone) as I unplugged that and started there.
Any help would be so sincerely appreciated????
- ...
- 127 posts total
| Post removed |
Back in my radio days we designed a very nice control room. Then the engineer laid all the mic lines on top of the data lines. I was the only person who could hear the problem, therefore it didn't exist. I'd try a trial separation, or, if it's not a big deal, unhook everything, add back a line at a time. It's a great opportunity to dust & polish also. |
Great replies @tkhill @strawj! I used the opportunity when I relocated a few things when I introduced the McIntosh to clean and dust-another great call on this thread! You guys truly are awesome! And my Hum-X will arrive Thursday so tomorrow I try plugging the McIntosh into a separate outlet direct and see if that makes the buzz go away. Next step if that doesn’t work is to unplug everything 1 at a time from my Furman Elite. Then plug everything back one at a time to see if it in fact maybe isn’t the McIntosh. But I have already unplugged several components including the 2 subs and the cable box and that didn’t change anything. So I’ll go all the way in tomorrow.
I did disconnect all my XLR IC’s from the Titan amp and there was no buzz so I know it’s not the power amp. My IC’s are all Transparent Plus so I know they’re solid. I really am almost convinced it’s the McIntosh but we’ll dig a bit more tomorrow…
Thank you all once again for supporting and going on this journey with me👍🏻! |
- 127 posts total