Is the EPI 100 an 8ohm load?

Sansui AU666

Nominal impedance is 8 ohms for the EPI 100 speakers.
http://www.epinions.com/review/Epicure_EPI_100_epi/content_560423800452

The amp should easily handle the speakers imo.
.

I run my EPI 100s with my Sansui AU D-11 in a second system. No problems.

Mt10425 - the AU D11 is 120 watts/channel, whereas the AU 666 is 38 wpc...

I think i should be fine anyway, but i'm not 100% sure. My sugden seemed to drive them just fine...before it blew a channel,that is (not from over-driving, mind you; the issue lies elsewhere).

* ohms
Link
http://www.epinions.com/specs/Epicure_EPI_100_epi

Thanks, Arh! I was on that page earlier, but didn't see the spec sheet... only the review portion.