The OP says that one tube in each amplifier “popped”. That is not the exit mode of tubes that wear out. Normally a tube that is dying due to long use will just begin to sound bad and eventually become impossible to bias properly until the user finally notices a problem and replaces it. Although catastrophic failure does occasionally occur, most commonly at start-up, the amplifier needs to be evaluated.
Life of KT 150 Tubes
Auris audio Mono Block -Forte 150 uses Two KT150 for power output for each monos, Very strangely a both amps popped the KT 150 same time. I can vouch it had less than 1000 hours in 2 years as I have NAIM NAC 252/NAP 300 in the same room. I tested the tubes and one is 100% dead and the rest have very marginal life. With great difficulty I have ordered four new tubes. Would any of you know why this would have happened, in the sense bath amps not working at the same time? I am trying to get hold of Auris in Serbia. Even a good Valve tech will not open the unit without schematics and Auris wouldn’t provide one. I am in Canada. There are 2 authorized service center in the US. When crated both amp weighs 94 Kgs.Not easy to ship. I tried with a borrowed set of TUBES , there is no Biasing at all,mA reads 0, but there is signal coming in and VU display lights up.
Lesson learnt well not to buy equipment that is hard to service. I bought this even before there was a dealer in canada. I tried contacting the distributor Motet in Toronto. They are telling me to contact Dealer in Edmonton 300Km away. He never sold me the unit, why would he have any interest if he didn’t make any money on this unit? The unit cost $16,800 USD. Any advise what I should do?
- ...
- 53 posts total
- 53 posts total