2. amps-preamps
  3. 149759-113932

Looking to Add to my 7100

Hi
Thinking of adding another (McIntosh 7100 power amp) to the one i have (C-26 pre) can any one explain how to do mono block.  (One 7100 does not seem to be enough power) to push my (Platinum Audio Solo's) I have to crank it up to ## 7 or 8 to get it to sing.... (Thanks in advance)
                                                    Jefferson 
128x128mantaman
mcreyn
293 posts
 
Where you set your volume on your preamp has nothing to with whether your amp is running out of power, only the gain of your preamp.

Are you in fact running out of power? Your amp has a clipping light on it that will flash if it is. Is it flashing? Does it flash if you turn it up a little further?  Where are the gain controls set on the 7100?
mantaman's avatar
mantaman OP
37 posts
 
Hi
and thank you for your reply, but that's not what i asked, yes it is clipping!!
yogiboy's avatar
yogiboy
5,509 posts
 
Here ya go!

MONOPHONIC (BRIDGED) OPERATION A rear panel MODE switch allows the MC7100 to be used as a normal stereo amplifier, or as a bridged mono amplifier. Connect a shielded cable from a mono signal source to the R (right) /MONO input jack on the MC7100. Set the mode switch to MONO. Only the right channel LEVEL control func- tions in MONO operation. The outputs must be connected as indicated in HOW TO CONNECT OUTPUTS for proper mono operation.

The owners manual!
https://www.manualslib.com/manual/1018221/Mcintosh-Mc7100.html

Post removed 
More to discover