Klipsch Palladium P39F and Probably the Entire line Major issue!


I have a pair of P39F's and have had an issue for a while with one of the 9" woofers.  The rubber surround that is connected to the aluminum cap on the cone was separating.  Today I thought I would see if I could get the decorative cover off that hides the screws, it is over $100, so I didn't want to have to buy it to when I replaced the torn woofer.  I managed to remove the cover and then I looked up at the rest of my woofers in the cabinet and to my surprise  the other two woofers have the surround separating too. 

I then took the cover off my other P39  and it's surrounds are starting to separate to. 


Something really stinks, six woofers separating, Klipsch is this why you discontinued the Palladium's?  Maybe anyone out there that has Palladium's should take a look at the rubber surrounds.  Klipsch use the same technique on the entire line for the surrounds, not just the P39's but all of them.


Anybody know of a hidden recall or something?  this isn't right, Klipsch this shouldn't be happening on a pair of $20,000 speakers!!!

78c3sam
Same happened to me on a pair of Vandersteen 2CE speakers.  Sent the woofers back for repair. Richard Vandersteen told me the speakers were too close to the baseboard heat in my home. Lesson learned. 
Klipsch is known for standing behind their products. Give them a call before blowing a gasket.

I contacted them, they said maybe if my warranty was still valid, but they are out of warranty by a few years.  I asked if they re-cone, didn't get an answer, asked if there was a core charge since the p39 is the only one with the 9" woofer and at some point they will not have any left if someone else needs replacements, waiting  to see what they come back with.

I asked how much for all 6 woofers, maybe I can get a discount since I am replacing all of them, waiting on that ....

Post removed 

no need for me to cool off, just pointing out that if this is a problem with Palladium's, everyone out there that purchased any Palladium will be seeing this issue sooner or later.


Also, it is not just that the rubber surround has simply separated, it is if there were some kind of chemical reaction that caused the surround to deteriate where it touches the aluminum cone cap..

Because of this, it is not a simple glue job but a replace or