40hz ratings/speaker response

A speaker rated down to 40hz will play below the frequency, just rolled off. The amount of rolloff depends on the type of low freq. system. Bass reflex rolls off at twice rate of acoustic suspension below the low frequency resononce. But with room gain, a speaker rated down to 40hz ("faithfully" i.e. +/-2db etc.) would still reproduce down through the 30's and even some of the 20's depending on the room. Small rooms can offer 9db of gain at 20hz. You turn it up, and like with any driver, distortion will go up.

OK, time to get specific. Heres the crux of my problem.
the speaker in question is a B&W Nautilus804. the exact specs are: freq.range= -6db at 30hz and 30khz. and
-3db at 38hz and 22khz. the freq. response rating is:
45hz-20khz +/-2db. Now, to get more specific: last week I dug out an older Bonnie Raitt tape, for one song, just her voice, piano, and an occassional string/cello, lite guitar etc. Feeling somewhat nostalgic I turned it up pretty high(love that piano). Whereupon a woofer started to "rattle". I immediatley turned it down, inspected the speaker, seeing no damage, tried a different cd and the same results with some higher volume. My electronics are Classe CA300 amp, and Classe cp50 pre-amp. My BW dealer has agreed to replace the speaker no problem. But the speaker didn't tear, or pop, or freeze, it "rattled". Could that be something wrong with the electronics and not the speaker?

Wow it's so cool when everyone offers such great insight/advise. Keep in mind that the bass lift most rooms provide is not linear. It's probably your speaker that has failed you. If it's only one channel, reverse speakers to confirm the (1) speaker is the culprit. If not work your way back by reversing the the cable left to right and right to left, one by one from end to source. Eventually you will find the culprit. My guess it will be sooner rather than later. If it effects both channels you will need to find replacement gear and substitute end to source (try changing sources at the preamp first ) or have each piece bench checked. Good luck.

Speakers of various designs and tuning will respond differently when fed a signal below their natural resonance ( point of max output ). Well designed acoustic suspension ( sealed box ), infinite baffle ( designs that make use of huge volumes of air and a baffle to isolate the rear wave from the front wave ) and TL ( transmission line ) designs will respond relatively linearly but at reduced output.

Vented designs, such as ports, passive radiators, slot loaded, etc... will produce much lower output below that point with greater potential for distortion and even driver damage.

If you doubt this, try playing a highy warped record with a large speaker that is vented at high volume. The woofer will want to pop out of its' basket. This is one of the reasons why the "high pass filter" or "rumble filter" was invented.

While you would have similar results with a sealed box, the driver would not be nearly as "out of control". This is due to the damping that the "air spring" in the box supplies. Vented designs are "unloaded" or have no "damping" below the point of box tuning. The driver is therefore subject to greater excursion, which could result in damage. This damage could be immediate or accumulative over time.

With that in mind, most people with educated ears are able to discern the differences between vented and sealed designs simply by listening. One obviously sounds more natural and linear than the other. Sean
>

Thanks for the info folks. You have to be careful about jumping to conclusions based on that spec.

I would much rather have a speaker rated 40hz or so that handled that really well than most speakers sold today rated below that number. Northcreek is a good example.

Cheers,